Hello,
first of all: thank you for this patch!
On Mon, Jun 19, 2023 at 7:36 PM Ziyang Huang <hzyitc@xxxxxxxxxxx> wrote:
>
> Commit 4bc31edebde5 ("mmc: core: Set HS clock speed before sending
> HS CMD13") set HS clock (52MHz) before switching to HS mode. For this
> freq, FCLK_DIV5 will be selected and div value is 10 (reg value is 9).
> Then we set rx_clk_phase to 11 or 15 which is out of range and make
> hardware frozen. After we send command request, no irq will be
> interrupted and the mmc driver will keep to wait for request finished,
> even durning rebooting.
I think this is the exact same problem I reported some days ago: [0]
Ulf is questioning whether we properly support 52MHz clocks correctly,
so I think you're onto something!
So this is an excellent finding! I can confirm that using rx_clk_phase
of 1 makes my Odroid-C1 eMMC work again :-)
> So let's set a common value - 1 just for initialization. Then let
> meson_mx_sdhc_execute_tuning() to find the accurate value for data
> transfer.
As far as I know unconditionally using value 1 can negatively affect
other devices.
I'm assuming that you're testing on an Odroid-C1 or similar board with
HS200 eMMC:
On those SoC + eMMC combinations we do support. But on other boards
(for example Meson8b EC-100 / Endless Mini) there's no HS200 support
because the eMMC is connected with 3.3V IO lines. So tuning is not
executed there (if I recall correctly).
What do you think about adding a special case for the 51MHz "actual
clock rate" and adding a comment that it was found by manual testing?
For some reason (that I don't understand) Amlogic's vendor driver
maxes out at 47.22MHz (presumably because they limit themselves to
using FCLK_DIV3 as input only - but I don't get why...).
Best regards,
Martin
[0] https://lore.kernel.org/linux-amlogic/CAFBinCD0RT0p-jk86W0JuMT3ufohRh1RqWCcM35DKZJpuc10HQ@xxxxxxxxxxxxxx/
[1] https://lore.kernel.org/linux-amlogic/CAPDyKFpS-UwiaRPMqSpX0mNPrS5p=yJzu3g0=pGyCkWHSYyqWg@xxxxxxxxxxxxxx/
