On 20/08/2022 21:57, Brad Larson wrote:
> From: Brad Larson <blarson@xxxxxxx>
>
> Add AMD Pensando common and Elba SoC specific device nodes
>
> Signed-off-by: Brad Larson <blarson@xxxxxxx>
(...)
> +
> +&ahb_clk {
> + clock-frequency = <400000000>;
> +};
> +
> +&emmc_clk {
> + clock-frequency = <200000000>;
> +};
> +
> +&flash_clk {
> + clock-frequency = <400000000>;
> +};
> +
> +&ref_clk {
> + clock-frequency = <156250000>;
> +};
> +
> +&qspi {
> + status = "okay";
Blank line between properties and device nodes.
> + flash0: flash@0 {
> + compatible = "jedec,spi-nor";
> + reg = <0>;
> + spi-max-frequency = <40000000>;
> + spi-rx-bus-width = <2>;
> + m25p,fast-read;
> + cdns,read-delay = <0>;
> + cdns,tshsl-ns = <0>;
> + cdns,tsd2d-ns = <0>;
> + cdns,tchsh-ns = <0>;
> + cdns,tslch-ns = <0>;
> + };
> +};
> +
> +&gpio0 {
> + status = "okay";
> +};
> +
> +&emmc {
> + bus-width = <8>;
> + cap-mmc-hw-reset;
> + reset-names = "hw";
> + resets = <&rstc 0>;
> + status = "okay";
> +};
> +
> +&wdt0 {
> + status = "okay";
> +};
> +
> +&i2c0 {
> + clock-frequency = <100000>;
> + status = "okay";
Blank line between properties and device nodes.
> + rtc@51 {
> + compatible = "nxp,pcf85263";
> + reg = <0x51>;
> + };
> +};
> +
> +&spi0 {
> + num-cs = <4>;
> + cs-gpios = <0>, <0>, <&porta 1 GPIO_ACTIVE_LOW>,
> + <&porta 7 GPIO_ACTIVE_LOW>;
> + status = "okay";
Blank line between properties and device nodes.
> + sysc: system-controller@0 {
> + compatible = "amd,pensando-elbasr";
Best regards,
Krzysztof
