On Mon, 16 Aug 2021 at 16:23, Mårten Lindahl <marten.lindahl@xxxxxxxx> wrote:
>
> When switching card voltage to UHS voltage the mmc framework tries to
> check the card busy signal, meaning the card pulling DAT0 line low,
> before the switch is made. Drivers that does not implement the card_busy
> function will manage to do the switch anyway, but the framework will
> print a warning about not being able to verify the voltage signal.
>
> Implement card_busy function.
>
> Signed-off-by: Mårten Lindahl <marten.lindahl@xxxxxxxx>
Applied for next, thanks!
Kind regards
Uffe
> ---
>
> v2:
> - Update commit message, since interface limitation for checking DAT
> lines is not valid for this fix.
> - Skip check of SCLKDIVEN bit, and skip check of DAT3 line since SD
> specification only points out checking DAT0 for busy signal.
> - Update comment about card_busy callback.
>
> v3:
> - Split header file change into separate patch.
>
> drivers/mmc/host/usdhi6rol0.c | 10 ++++++++++
> 1 file changed, 10 insertions(+)
>
> diff --git a/drivers/mmc/host/usdhi6rol0.c b/drivers/mmc/host/usdhi6rol0.c
> index b9b79b1089a0..b5ab133e9add 100644
> --- a/drivers/mmc/host/usdhi6rol0.c
> +++ b/drivers/mmc/host/usdhi6rol0.c
> @@ -1186,6 +1186,15 @@ static int usdhi6_sig_volt_switch(struct mmc_host *mmc, struct mmc_ios *ios)
> return ret;
> }
>
> +static int usdhi6_card_busy(struct mmc_host *mmc)
> +{
> + struct usdhi6_host *host = mmc_priv(mmc);
> + u32 tmp = usdhi6_read(host, USDHI6_SD_INFO2);
> +
> + /* Card is busy if it is pulling dat[0] low */
> + return !(tmp & USDHI6_SD_INFO2_SDDAT0);
> +}
> +
> static const struct mmc_host_ops usdhi6_ops = {
> .request = usdhi6_request,
> .set_ios = usdhi6_set_ios,
> @@ -1193,6 +1202,7 @@ static const struct mmc_host_ops usdhi6_ops = {
> .get_ro = usdhi6_get_ro,
> .enable_sdio_irq = usdhi6_enable_sdio_irq,
> .start_signal_voltage_switch = usdhi6_sig_volt_switch,
> + .card_busy = usdhi6_card_busy,
> };
>
> /* State machine handlers */
> --
> 2.20.1
>
