According to SD specification checking state of DAT0 only is enough for
polling card busy signal. Header file comment says DAT[0:3]. Fix this.
Signed-off-by: Mårten Lindahl <marten.lindahl@xxxxxxxx>
---
include/linux/mmc/host.h | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/include/linux/mmc/host.h b/include/linux/mmc/host.h
index 0abd47e9ef9b..ff1a251bb0bc 100644
--- a/include/linux/mmc/host.h
+++ b/include/linux/mmc/host.h
@@ -153,7 +153,7 @@ struct mmc_host_ops {
int (*start_signal_voltage_switch)(struct mmc_host *host, struct mmc_ios *ios);
- /* Check if the card is pulling dat[0:3] low */
+ /* Check if the card is pulling dat[0] low */
int (*card_busy)(struct mmc_host *host);
/* The tuning command opcode value is different for SD and eMMC cards */
--
2.20.1
