Add binding documentation for mmc host controllers present on TI's J7200 SOC Signed-off-by: Faiz Abbas <faiz_abbas@xxxxxx> --- Documentation/devicetree/bindings/mmc/sdhci-am654.txt | 6 +++++- 1 file changed, 5 insertions(+), 1 deletion(-) diff --git a/Documentation/devicetree/bindings/mmc/sdhci-am654.txt b/Documentation/devicetree/bindings/mmc/sdhci-am654.txt index 6d202f4d9249..b49cbfdd679f 100644 --- a/Documentation/devicetree/bindings/mmc/sdhci-am654.txt +++ b/Documentation/devicetree/bindings/mmc/sdhci-am654.txt @@ -12,6 +12,8 @@ Required Properties: "ti,am654-sdhci-5.1": SDHCI on AM654 device. "ti,j721e-sdhci-8bit": 8 bit SDHCI on J721E device. "ti,j721e-sdhci-4bit": 4 bit SDHCI on J721E device. + "ti,j7200-sdhci-8bit": 8 bit SDHCI on J7200 device. + "ti,j7200-sdhci-4bit": 4 bit SDHCI on J7200 device. - reg: Must be two entries. - The first should be the sdhci register space - The second should the subsystem/phy register space @@ -33,7 +35,9 @@ Required Properties: These bindings must be provided otherwise the driver will disable the corresponding speed mode (i.e. all nodes must provide at least -legacy) -Optional Properties (Required for ti,am654-sdhci-5.1 and ti,j721e-sdhci-8bit): +Optional Properties (Required for ti,am654-sdhci-5.1, + ti,j721e-sdhci-8bit, + ti,j7200-sdhci-8bit): - ti,trm-icp: DLL trim select - ti,driver-strength-ohm: driver strength in ohms. Valid values are 33, 40, 50, 66 and 100 ohms. -- 2.17.1
