On Thu, 16 Mar 2017 09:20:51 +0800 Shawn Lin wrote: > Currently the get_timeout_clock callabck doesn't clearly > have a statment that it needs the variant drivers to return > the timeout clock rate in KHz if the SDHCI_TIMEOUT_CLK_UNIT > isn't present, otherwise the variant drivers should return it > in KHz. So actually sdhci-of-arasan return the wrong value found > by Anssi[1]. It's also very likely that further variant drivers which > are going to use this callback will be confused by this situation. > Given the fact that modem sdhci variant hosts are very prone to get > the timeout clock from common clock framework(actuall the only three > users did that), it's more nature to return the value in Hz and we > make a explicit comment there. Then we put the unit conversion inside > the sdhci core. Thus will improve the code and prevent further misues. > > [1]: https://patchwork.kernel.org/patch/9569431/ I think we need a blank line here > Cc: Adrian Hunter <adrian.hunter@xxxxxxxxx> > Cc: Anssi Hannula <anssi.hannula@xxxxxxxxxx> > Cc: Masahiro Yamada <yamada.masahiro@xxxxxxxxxxxxx> > Signed-off-by: Shawn Lin <shawn.lin@xxxxxxxxxxxxxx> > This blank line need to be removed. > Acked-by: Masahiro Yamada <yamada.masahiro@xxxxxxxxxxxxx> > --- > > Changes in v4: > - rebased on -next > - add Masahiro's ack for sdhci-cadence > > Changes in v3: > - squash all the patches into one to keep bisectability > - fix wrong return value of sdhci-cadence > - slight improve the condition check to avoid the complaint of > checkpatch > > Changes in v2: > - fix the comment and make it return in Hz > > drivers/mmc/host/sdhci-cadence.c | 4 ++-- > drivers/mmc/host/sdhci-of-arasan.c | 17 +---------------- > drivers/mmc/host/sdhci.c | 16 +++++++++------- > drivers/mmc/host/sdhci.h | 1 + > 4 files changed, 13 insertions(+), 25 deletions(-) > > diff --git a/drivers/mmc/host/sdhci-cadence.c b/drivers/mmc/host/sdhci-cadence.c > index 316cfec..7baeeaf 100644 > --- a/drivers/mmc/host/sdhci-cadence.c > +++ b/drivers/mmc/host/sdhci-cadence.c > @@ -103,9 +103,9 @@ static unsigned int sdhci_cdns_get_timeout_clock(struct sdhci_host *host) > { > /* > * Cadence's spec says the Timeout Clock Frequency is the same as the > - * Base Clock Frequency. Divide it by 1000 to return a value in kHz. > + * Base Clock Frequency. > */ > - return host->max_clk / 1000; > + return host->max_clk; > } > > static void sdhci_cdns_set_uhs_signaling(struct sdhci_host *host, > diff --git a/drivers/mmc/host/sdhci-of-arasan.c b/drivers/mmc/host/sdhci-of-arasan.c > index 1cfd7f9..c52f153 100644 > --- a/drivers/mmc/host/sdhci-of-arasan.c > +++ b/drivers/mmc/host/sdhci-of-arasan.c > @@ -157,21 +157,6 @@ static int sdhci_arasan_syscon_write(struct sdhci_host *host, > return ret; > } > > -static unsigned int sdhci_arasan_get_timeout_clock(struct sdhci_host *host) > -{ > - unsigned long freq; > - struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host); > - > - /* SDHCI timeout clock is in kHz */ > - freq = DIV_ROUND_UP(clk_get_rate(pltfm_host->clk), 1000); > - > - /* or in MHz */ > - if (host->caps & SDHCI_TIMEOUT_CLK_UNIT) > - freq = DIV_ROUND_UP(freq, 1000); > - > - return freq; > -} > - > static void sdhci_arasan_set_clock(struct sdhci_host *host, unsigned int clock) > { > struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host); > @@ -286,7 +271,7 @@ static int sdhci_arasan_voltage_switch(struct mmc_host *mmc, > static struct sdhci_ops sdhci_arasan_ops = { > .set_clock = sdhci_arasan_set_clock, > .get_max_clock = sdhci_pltfm_clk_get_max_clock, > - .get_timeout_clock = sdhci_arasan_get_timeout_clock, > + .get_timeout_clock = sdhci_pltfm_clk_get_max_clock, > .set_bus_width = sdhci_set_bus_width, > .reset = sdhci_arasan_reset, > .set_uhs_signaling = sdhci_set_uhs_signaling, > diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c > index 6fdd7a7..f73494e 100644 > --- a/drivers/mmc/host/sdhci.c > +++ b/drivers/mmc/host/sdhci.c > @@ -3289,20 +3289,22 @@ int sdhci_setup_host(struct sdhci_host *host) > if (!(host->quirks & SDHCI_QUIRK_DATA_TIMEOUT_USES_SDCLK)) { > host->timeout_clk = (host->caps & SDHCI_TIMEOUT_CLK_MASK) >> > SDHCI_TIMEOUT_CLK_SHIFT; > + > + if (host->caps & SDHCI_TIMEOUT_CLK_UNIT) > + host->timeout_clk *= 1000; > + > if (host->timeout_clk == 0) { > - if (host->ops->get_timeout_clock) { > - host->timeout_clk = > - host->ops->get_timeout_clock(host); > - } else { > + if (unlikely(!host->ops->get_timeout_clock)) { > pr_err("%s: Hardware doesn't specify timeout clock frequency.\n", > mmc_hostname(mmc)); > ret = -ENODEV; > goto undma; > } > - } > > - if (host->caps & SDHCI_TIMEOUT_CLK_UNIT) > - host->timeout_clk *= 1000; > + host->timeout_clk = > + DIV_ROUND_UP(host->ops->get_timeout_clock(host), > + 1000); > + } > > if (override_timeout_clk) > host->timeout_clk = override_timeout_clk; > diff --git a/drivers/mmc/host/sdhci.h b/drivers/mmc/host/sdhci.h > index edf3adf..27c252c 100644 > --- a/drivers/mmc/host/sdhci.h > +++ b/drivers/mmc/host/sdhci.h > @@ -547,6 +547,7 @@ struct sdhci_ops { > int (*enable_dma)(struct sdhci_host *host); > unsigned int (*get_max_clock)(struct sdhci_host *host); > unsigned int (*get_min_clock)(struct sdhci_host *host); > + /* get_timeout_clock should return clk rate in unit of Hz */ > unsigned int (*get_timeout_clock)(struct sdhci_host *host); > unsigned int (*get_max_timeout_count)(struct sdhci_host *host); > void (*set_timeout)(struct sdhci_host *host, -- To unsubscribe from this list: send the line "unsubscribe linux-mmc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
