Currently the get_timeout_clock callabck doesn't clearly have a statment that it needs the variant drivers to return the timeout clock rate in KHz if the SDHCI_TIMEOUT_CLK_UNIT isn't present, otherwise the variant drivers should return it in KHz. So actually sdhci-of-arasan return the wrong value found by Anssi[1]. It's also very likely that further variant drivers which are going to use this callback will be confused by this situation. Given the fact that modem sdhci variant hosts are very prone to get the timeout clock from common clock framework(actuall the only three users did that), it's more nature to return the value in Hz and we make a explicit comment there. Then we put the unit conversion inside the sdhci core. Thus will improve the code and prevent further misues. [1]: https://patchwork.kernel.org/patch/9569431/ Cc: Adrian Hunter <adrian.hunter@xxxxxxxxx> Cc: Anssi Hannula <anssi.hannula@xxxxxxxxxx> Cc: Masahiro Yamada <yamada.masahiro@xxxxxxxxxxxxx> Signed-off-by: Shawn Lin <shawn.lin@xxxxxxxxxxxxxx> Acked-by: Masahiro Yamada <yamada.masahiro@xxxxxxxxxxxxx> --- Changes in v4: - rebased on -next - add Masahiro's ack for sdhci-cadence Changes in v3: - squash all the patches into one to keep bisectability - fix wrong return value of sdhci-cadence - slight improve the condition check to avoid the complaint of checkpatch Changes in v2: - fix the comment and make it return in Hz drivers/mmc/host/sdhci-cadence.c | 4 ++-- drivers/mmc/host/sdhci-of-arasan.c | 17 +---------------- drivers/mmc/host/sdhci.c | 16 +++++++++------- drivers/mmc/host/sdhci.h | 1 + 4 files changed, 13 insertions(+), 25 deletions(-) diff --git a/drivers/mmc/host/sdhci-cadence.c b/drivers/mmc/host/sdhci-cadence.c index 316cfec..7baeeaf 100644 --- a/drivers/mmc/host/sdhci-cadence.c +++ b/drivers/mmc/host/sdhci-cadence.c @@ -103,9 +103,9 @@ static unsigned int sdhci_cdns_get_timeout_clock(struct sdhci_host *host) { /* * Cadence's spec says the Timeout Clock Frequency is the same as the - * Base Clock Frequency. Divide it by 1000 to return a value in kHz. + * Base Clock Frequency. */ - return host->max_clk / 1000; + return host->max_clk; } static void sdhci_cdns_set_uhs_signaling(struct sdhci_host *host, diff --git a/drivers/mmc/host/sdhci-of-arasan.c b/drivers/mmc/host/sdhci-of-arasan.c index 1cfd7f9..c52f153 100644 --- a/drivers/mmc/host/sdhci-of-arasan.c +++ b/drivers/mmc/host/sdhci-of-arasan.c @@ -157,21 +157,6 @@ static int sdhci_arasan_syscon_write(struct sdhci_host *host, return ret; } -static unsigned int sdhci_arasan_get_timeout_clock(struct sdhci_host *host) -{ - unsigned long freq; - struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host); - - /* SDHCI timeout clock is in kHz */ - freq = DIV_ROUND_UP(clk_get_rate(pltfm_host->clk), 1000); - - /* or in MHz */ - if (host->caps & SDHCI_TIMEOUT_CLK_UNIT) - freq = DIV_ROUND_UP(freq, 1000); - - return freq; -} - static void sdhci_arasan_set_clock(struct sdhci_host *host, unsigned int clock) { struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host); @@ -286,7 +271,7 @@ static int sdhci_arasan_voltage_switch(struct mmc_host *mmc, static struct sdhci_ops sdhci_arasan_ops = { .set_clock = sdhci_arasan_set_clock, .get_max_clock = sdhci_pltfm_clk_get_max_clock, - .get_timeout_clock = sdhci_arasan_get_timeout_clock, + .get_timeout_clock = sdhci_pltfm_clk_get_max_clock, .set_bus_width = sdhci_set_bus_width, .reset = sdhci_arasan_reset, .set_uhs_signaling = sdhci_set_uhs_signaling, diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c index 6fdd7a7..f73494e 100644 --- a/drivers/mmc/host/sdhci.c +++ b/drivers/mmc/host/sdhci.c @@ -3289,20 +3289,22 @@ int sdhci_setup_host(struct sdhci_host *host) if (!(host->quirks & SDHCI_QUIRK_DATA_TIMEOUT_USES_SDCLK)) { host->timeout_clk = (host->caps & SDHCI_TIMEOUT_CLK_MASK) >> SDHCI_TIMEOUT_CLK_SHIFT; + + if (host->caps & SDHCI_TIMEOUT_CLK_UNIT) + host->timeout_clk *= 1000; + if (host->timeout_clk == 0) { - if (host->ops->get_timeout_clock) { - host->timeout_clk = - host->ops->get_timeout_clock(host); - } else { + if (unlikely(!host->ops->get_timeout_clock)) { pr_err("%s: Hardware doesn't specify timeout clock frequency.\n", mmc_hostname(mmc)); ret = -ENODEV; goto undma; } - } - if (host->caps & SDHCI_TIMEOUT_CLK_UNIT) - host->timeout_clk *= 1000; + host->timeout_clk = + DIV_ROUND_UP(host->ops->get_timeout_clock(host), + 1000); + } if (override_timeout_clk) host->timeout_clk = override_timeout_clk; diff --git a/drivers/mmc/host/sdhci.h b/drivers/mmc/host/sdhci.h index edf3adf..27c252c 100644 --- a/drivers/mmc/host/sdhci.h +++ b/drivers/mmc/host/sdhci.h @@ -547,6 +547,7 @@ struct sdhci_ops { int (*enable_dma)(struct sdhci_host *host); unsigned int (*get_max_clock)(struct sdhci_host *host); unsigned int (*get_min_clock)(struct sdhci_host *host); + /* get_timeout_clock should return clk rate in unit of Hz */ unsigned int (*get_timeout_clock)(struct sdhci_host *host); unsigned int (*get_max_timeout_count)(struct sdhci_host *host); void (*set_timeout)(struct sdhci_host *host, -- 1.9.1 -- To unsubscribe from this list: send the line "unsubscribe linux-mmc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
