When IS_ERR_VALUE was removed from the mmc core code, it was replaced
with a simple not-zero check. This does not work, as the value checked
is the return value for mmc_select_bus_width, which returns the set
bit width on success. This made eMMC modes higher than HS-DDR unusable.
Fix this by checking for a positive return value instead.
Fixes: 287980e49ffc ("remove lots of IS_ERR_VALUE abuses")
Cc: Arnd Bergmann <arnd@xxxxxxxx>
Signed-off-by: Chen-Yu Tsai <wens@xxxxxxxx>
---
drivers/mmc/core/mmc.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/mmc/core/mmc.c b/drivers/mmc/core/mmc.c
index c984321d1881..aafb73d080ca 100644
--- a/drivers/mmc/core/mmc.c
+++ b/drivers/mmc/core/mmc.c
@@ -1276,7 +1276,7 @@ static int mmc_select_hs200(struct mmc_card *card)
* switch to HS200 mode if bus width is set successfully.
*/
err = mmc_select_bus_width(card);
- if (!err) {
+ if (err > 0) {
val = EXT_CSD_TIMING_HS200 |
card->drive_strength << EXT_CSD_DRV_STR_SHIFT;
err = __mmc_switch(card, EXT_CSD_CMD_SET_NORMAL,
@@ -1583,7 +1583,7 @@ static int mmc_init_card(struct mmc_host *host, u32 ocr,
} else if (mmc_card_hs(card)) {
/* Select the desired bus width optionally */
err = mmc_select_bus_width(card);
- if (!err) {
+ if (err > 0) {
err = mmc_select_hs_ddr(card);
if (err)
goto free_card;
--
2.8.1
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
