The controller claims to support SDR104. In fact, it only supports a degraded SDR104 since the maximum frequency of the SD clock is 120 MHz instead of 208 MHz. The sdhci core is unaware of it and will compute a wrong clock divider. We can deal with this specific case by using presets. Signed-off-by: Ludovic Desroches <ludovic.desroches@xxxxxxxxx> --- drivers/mmc/host/sdhci-of-at91.c | 24 ++++++++++++++++++++++++ 1 file changed, 24 insertions(+) diff --git a/drivers/mmc/host/sdhci-of-at91.c b/drivers/mmc/host/sdhci-of-at91.c index c1923c0..76308b1 100644 --- a/drivers/mmc/host/sdhci-of-at91.c +++ b/drivers/mmc/host/sdhci-of-at91.c @@ -18,6 +18,7 @@ #include <linux/delay.h> #include <linux/err.h> #include <linux/io.h> +#include <linux/kernel.h> #include <linux/mmc/host.h> #include <linux/mmc/slot-gpio.h> #include <linux/module.h> @@ -163,6 +164,7 @@ static int sdhci_at91_probe(struct platform_device *pdev) unsigned int clk_base, clk_mul; unsigned int gck_rate, real_gck_rate; int ret; + unsigned int preset_div, preset_common = 0x400; /* drv type B, programmable clock mode */ match = of_match_device(sdhci_at91_dt_match, &pdev->dev); if (!match) @@ -230,6 +232,28 @@ static int sdhci_at91_probe(struct platform_device *pdev) clk_mul, real_gck_rate); } + /* + * We have to set preset values because it depends on the clk_mul + * value. Moreover, SDR104 is supported in a degraded mode since the + * maximum sd clock value is 120 MHz instead of 208 MHz. For that + * reason, we need to use presets to support SDR104. + */ + preset_div = DIV_ROUND_UP(real_gck_rate, 24000000) - 1; + writew(preset_common | preset_div, + host->ioaddr + SDHCI_PRESET_FOR_SDR12); + preset_div = DIV_ROUND_UP(real_gck_rate, 50000000) - 1; + writew(preset_common | preset_div, + host->ioaddr + SDHCI_PRESET_FOR_SDR25); + preset_div = DIV_ROUND_UP(real_gck_rate, 100000000) - 1; + writew(preset_common | preset_div, + host->ioaddr + SDHCI_PRESET_FOR_SDR50); + preset_div = DIV_ROUND_UP(real_gck_rate, 120000000) - 1; + writew(preset_common | preset_div, + host->ioaddr + SDHCI_PRESET_FOR_SDR104); + preset_div = DIV_ROUND_UP(real_gck_rate, 50000000) - 1; + writew(preset_common | preset_div, + host->ioaddr + SDHCI_PRESET_FOR_DDR50); + clk_prepare_enable(priv->mainck); clk_prepare_enable(priv->gck); -- 2.5.0 -- To unsubscribe from this list: send the line "unsubscribe linux-mmc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
