Hi, On 12/14/2015 07:56 PM, Carlo Caione wrote: > On Mon, Dec 14, 2015 at 10:24 AM, Yang, York <weijuny@xxxxxxxxxxxxxxxx> wrote: >> Hi, Carlo >> >> I don't think so. You may check the 9faac7b95, there are two changes in sd.c and sdhc.c. >> Surely the change in sdhc.c will not affect ASUS X205TA (bcm43341) since it is a SDIO device. >> Actually the calling sequence is this: mmc_sd_init_uhs_card() calls sdhci_execute_tuning(). In 9faac7b95, I enabled tuning for DDR50 in these two functions. >> If your function calling sequence is mmc_sdio_init_uhs_card()->sdhci_execute_tuning(), the tuning will not carried out, since you didn't enable tuning for DDR50 in mmc_sdio_init_uhs_card(). >> Unless you call sdhci_execute_tuning directly, the tuning command may go through be sent out. > > Hi Yang, > > On the unmodified master what I see is: > > - mmc_sdio_init_uhs_card() is called > - card->sw_caps.sd3_bus_mode is 0x14 > - card->sw_caps.sd3_bus_mode & SD_MODE_UHS_SDR50 is actually verified > (even though the tuning for DDR50 is not enabled) > - mmc_execute_tuning() is actually called As i know, When mode is UHS_SDR50, tuning is not mandatory. Even though i need to check the spec file, i think that condition check is strange. Best Regards, Jaehoon Chung > -- To unsubscribe from this list: send the line "unsubscribe linux-mmc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
