Hi Alexander, On Wed, Apr 23, 2014 at 3:42 PM, Alexander Shiyan <shc_work@xxxxxxx> wrote: > Wed, 23 Apr 2014 12:21:39 -0300 от Fabio Estevam <festevam@xxxxxxxxx>: >> On Wed, Apr 23, 2014 at 12:10 PM, Fabio Estevam <festevam@xxxxxxxxx> wrote: >> >> > ,but I get this error: >> > >> > mxc-mmc 10013000.sdhci: mxcmci_finish_data: -EILSEQ >> > mmc0: error -84 whilst initialising SD card >> > mmc0: host does not support reading read-only switch. assuming write-enable. >> > mmc0: new SDHC card at address b5a1 >> > mmcblk0: mmc0:b5a1 SD04G 3.69 GiB >> > mmcblk0: unknown partition table >> >> I forgot to mention that this error does not happen if I boot the >> non-dt kernel, so it seems to be related to dt only. > > Probably you should also use vmmc*_reg voltages from PMIC? On mx27pdk board the vmmc1_reg powers up the CMOS camera instead of mmc supply. Thanks -- To unsubscribe from this list: send the line "unsubscribe linux-mmc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
