Wed, 23 Apr 2014 12:21:39 -0300 от Fabio Estevam <festevam@xxxxxxxxx>:
> On Wed, Apr 23, 2014 at 12:10 PM, Fabio Estevam <festevam@xxxxxxxxx> wrote:
>
> > ,but I get this error:
> >
> > mxc-mmc 10013000.sdhci: mxcmci_finish_data: -EILSEQ
> > mmc0: error -84 whilst initialising SD card
> > mmc0: host does not support reading read-only switch. assuming write-enable.
> > mmc0: new SDHC card at address b5a1
> > mmcblk0: mmc0:b5a1 SD04G 3.69 GiB
> > mmcblk0: unknown partition table
>
> I forgot to mention that this error does not happen if I boot the
> non-dt kernel, so it seems to be related to dt only.
Probably you should also use vmmc*_reg voltages from PMIC?
---
��.n��������+%������w��{.n�����{��i��)�� jg��� �����ݢj����G���� ���j:+v���w�m������w�������h�����٥
