On Mon, Jan 20, 2014 at 03:03:50PM -0200, Fabio Estevam wrote:
> On Mon, Jan 20, 2014 at 2:48 PM, Russell King - ARM Linux
> <linux@xxxxxxxxxxxxxxxx> wrote:
>
> > So far so good. Now, what about this external oscillator which has its
> > own separate power control. My immediate thought is that this can be
> > specified via card_ext_clock - I would simply need to declare a fixed-rate
> > clock with either a regulator (power switch) controlled via a gpio (which
> > would probably be closer to the hardware) or a gpio as an enable... ah,
> > that requires me to write a common clock driver for that bit since this
> > is currently not modelled by CCF...
>
> Isn't this covered by the gpios property of fixed-clock?
>
> We do the following to enable the 26MHz codec clock in
> imx51-babbage.dts via GPIO4_26:
>
> clk_26M: codec_clock {
> compatible = "fixed-clock";
> reg=<0>;
> #clock-cells = <0>;
> clock-frequency = <26000000>;
> gpios = <&gpio4 26 GPIO_ACTIVE_LOW>;
> };
Not as far as I can see. fixed-clock appears to have two properies:
clock-frequency
clock-output-names
and nothing else. See of_fixed_clk_setup in drivers/clk/clk-fixed-rate.c.
You'll also find that the documentation in this file says this about it:
* DOC: basic fixed-rate clock that cannot gate
*
* Traits of this clock:
* prepare - clk_(un)prepare only ensures parents are prepared
* enable - clk_enable only ensures parents are enabled
* rate - rate is always a fixed value. No clk_set_rate support
* parent - fixed parent. No clk_set_parent support
So, I think the bit which you quote from imx51-babbage.dts is wishful
thinking on the part of the author of the DT file, rather than actually
being implemented in any way by the kernel DT support.
--
FTTC broadband for 0.8mile line: 5.8Mbps down 500kbps up. Estimation
in database were 13.1 to 19Mbit for a good line, about 7.5+ for a bad.
Estimate before purchase was "up to 13.2Mbit".
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
