On Sun, Jan 19, 2014 at 07:56:53PM -0800, Olof Johansson wrote: > diff --git a/Documentation/devicetree/bindings/mmc/mmc.txt b/Documentation/devicetree/bindings/mmc/mmc.txt > index 458b57f..962e0ee 100644 > --- a/Documentation/devicetree/bindings/mmc/mmc.txt > +++ b/Documentation/devicetree/bindings/mmc/mmc.txt > @@ -5,6 +5,8 @@ these definitions. > Interpreted by the OF core: > - reg: Registers location and length. > - interrupts: Interrupts used by the MMC controller. > +- clocks: Clocks needed for the host controller, if any. > +- clock-names: Goes with clocks above. > > Card detection: > If no property below is supplied, host native card detect is used. > @@ -30,6 +32,15 @@ Optional properties: > - cap-sdio-irq: enable SDIO IRQ signalling on this interface > - full-pwr-cycle: full power cycle of the card is supported > > +Card power and reset control: > +The following properties can be specified for cases where the MMC > +peripheral needs additional reset, regulator and clock lines. It is for > +example common for WiFi/BT adapters to have these separate from the main > +MMC bus: > + - card-reset-gpios: Specify GPIOs for card reset (reset active low) > + - card-external-vcc-supply: Regulator to drive (independent) card VCC > + - clock with name "card_ext_clock": External clock provided to the card > + This looks good. I can connect the wifi/bt power control to a regulator, and give that as the card-external-vcc-supply property. I can specify the WIFI/BT resets for card-reset-gpios. So far so good. Now, what about this external oscillator which has its own separate power control. My immediate thought is that this can be specified via card_ext_clock - I would simply need to declare a fixed-rate clock with either a regulator (power switch) controlled via a gpio (which would probably be closer to the hardware) or a gpio as an enable... ah, that requires me to write a common clock driver for that bit since this is currently not modelled by CCF... -- FTTC broadband for 0.8mile line: 5.8Mbps down 500kbps up. Estimation in database were 13.1 to 19Mbit for a good line, about 7.5+ for a bad. Estimate before purchase was "up to 13.2Mbit". -- To unsubscribe from this list: send the line "unsubscribe linux-mmc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
