If the WAKEUP_INT is asserted at wakeup and not cleared, we'll end up
looping around forever.
Signed-off-by: Doug Anderson <dianders@xxxxxxxxxxxx>
---
drivers/mmc/host/dw_mmc-exynos.c | 23 +++++++++++++++++++++++
1 file changed, 23 insertions(+)
diff --git a/drivers/mmc/host/dw_mmc-exynos.c b/drivers/mmc/host/dw_mmc-exynos.c
index f013e7e..84d3b78 100644
--- a/drivers/mmc/host/dw_mmc-exynos.c
+++ b/drivers/mmc/host/dw_mmc-exynos.c
@@ -30,6 +30,7 @@
#define SDMMC_CLKSEL_TIMING(x, y, z) (SDMMC_CLKSEL_CCLK_SAMPLE(x) | \
SDMMC_CLKSEL_CCLK_DRIVE(y) | \
SDMMC_CLKSEL_CCLK_DIVIDER(z))
+#define SDMMC_CLKSEL_WAKEUP_INT BIT(11)
#define SDMMC_CMD_USE_HOLD_REG BIT(29)
@@ -102,6 +103,27 @@ static int dw_mci_exynos_setup_clock(struct dw_mci *host)
return 0;
}
+/**
+ * dw_mci_exynos_resume - Exynos-specific resume code
+ *
+ * We have seen cases (at least on the exynos5420) where turning off the INT
+ * power rail during suspend will leave the WAKEUP_INT bit in the CLKSEL
+ * register asserted. This bit is 1 to indicate that it fired and we can
+ * clear it by writing a 1 back. Clear it to prevent interrupts from going off
+ * constantly.
+ */
+
+static int dw_mci_exynos_resume(struct dw_mci *host)
+{
+ u32 clksel;
+
+ clksel = mci_readl(host, CLKSEL);
+ if (clksel & SDMMC_CLKSEL_WAKEUP_INT)
+ mci_writel(host, CLKSEL, clksel);
+
+ return 0;
+}
+
static void dw_mci_exynos_prepare_command(struct dw_mci *host, u32 *cmdr)
{
/*
@@ -165,6 +187,7 @@ static const struct dw_mci_drv_data exynos_drv_data = {
.caps = exynos_dwmmc_caps,
.init = dw_mci_exynos_priv_init,
.setup_clock = dw_mci_exynos_setup_clock,
+ .resume = dw_mci_exynos_resume,
.prepare_command = dw_mci_exynos_prepare_command,
.set_ios = dw_mci_exynos_set_ios,
.parse_dt = dw_mci_exynos_parse_dt,
--
1.8.3
--
To unsubscribe from this list: send the line "unsubscribe linux-mmc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
