On Thu, 13 Jun 2013, Linus Walleij wrote: > On Thu, Jun 6, 2013 at 9:14 PM, Balaji T K <balajitk@xxxxxx> wrote: > > > PBIAS register configuration is based on the regulator voltage > > which supplies these pbias cells, sd i/o pads. > > With PBIAS register address and bit definitions different across > > omap[3,4,5], Simplify PBIAS configuration under three different > > regulator voltage levels - O V, 1.8 V, 3 V. Corresponding pinctrl states > > are defined as pbias_off, pbias_1v8, pbias_3v. > > > > pinctrl state mmc_init is used for configuring speed mode, loopback clock > > (in devconf0/devconf1/prog_io1 register for omap3) and pull strength > > configuration (in control_mmc1 for omap4) > > > > Signed-off-by: Balaji T K <balajitk@xxxxxx> > > You *need* Lee Jones and Mark Brown to review this. > Maybe Laurent has something to add too. > > Ux500 had the very same thing, and there this was solved using > a GPIO regulator for "vqmmc" a level-shifter. I vaguely remember > Laurent doing something similar with the SH stuff. I haven't seem much of this patch-set, but this certainly looks like it should be handled by a GPIO regulator instead of pinctrl. States are easily declared in a 'struct gpio_regulator_state', which the framework then uses to set the correct pins for the required voltage. And yes, 'vqmmc' is a good place to store the this regulator. -- Lee Jones Linaro ST-Ericsson Landing Team Lead Linaro.org │ Open source software for ARM SoCs Follow Linaro: Facebook | Twitter | Blog -- To unsubscribe from this list: send the line "unsubscribe linux-mmc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
