Hi, On Wed, Sep 19 2012, Jaehoon Chung wrote: >> On Wed, Sep 19 2012, Tomasz Figa wrote: >>> We could just check if the regulator provides the capability to change the >>> voltage. >>> >>> I don't see any direct way of querying the regulator for provided >>> capabilities (correct me if I'm just blind), but calling >>> regulator_count_voltages() on the regulator and checking if the returned >>> value is 1 should be enough to assume that the regulator is fixed. >> >> Sounds good, I agree. Are you able to test that the obvious patch below >> works on your fixed-regulator board? >> >> Jaehoon and Adrian, can you think of any reason why we shouldn't replace >> MMC_CAP2_BROKEN_VOLTAGE with the regulator_count_voltages() call below? >> Thanks. > > I think this is better than using MMC_CAP2_BROKEN_VOLTAGE. > I tested with this..and working fine. Great, here's the patch. Jaehoon, once this is merged, maybe you could help remove the uses of MMC_CAP2_BROKEN_VOLTAGE from arch/arm/mach-exynos and arch/arm/mach-s5pv210 now that they're no longer needed? Thanks, - Chris. Subject: [PATCH] mmc: core: Replace MMC_CAP2_BROKEN_VOLTAGE with test for fixed regulator Before this patch, we were using MMC_CAP2_BROKEN_VOLTAGE as a way to avoid calling regulator_set_voltage() on a fixed regulator, but that's just duplicating information that already exists -- we should test whether the regulator is fixed directly, instead of via a capability. This patch implements that test. We can't reclaim the capability bit just yet, since there are still boards in arch/arm/ that reference it; those references can be removed now. Reported-by: Tomasz Figa <t.figa@xxxxxxxxxxx> Signed-off-by: Chris Ball <cjb@xxxxxxxxxx> --- drivers/mmc/core/core.c | 10 ++++++---- 1 file changed, 6 insertions(+), 4 deletions(-) diff --git a/drivers/mmc/core/core.c b/drivers/mmc/core/core.c index 044cd01..6612163 100644 --- a/drivers/mmc/core/core.c +++ b/drivers/mmc/core/core.c @@ -1113,7 +1113,8 @@ int mmc_regulator_set_ocr(struct mmc_host *mmc, int tmp; int voltage; - /* REVISIT mmc_vddrange_to_ocrmask() may have set some + /* + * REVISIT mmc_vddrange_to_ocrmask() may have set some * bits this regulator doesn't quite support ... don't * be too picky, most cards and regulators are OK with * a 0.1V range goof (it's a small error percentage). @@ -1127,12 +1128,13 @@ int mmc_regulator_set_ocr(struct mmc_host *mmc, max_uV = min_uV + 100 * 1000; } - /* avoid needless changes to this voltage; the regulator - * might not allow this operation + /* + * If we're using a fixed/static regulator, don't call + * regulator_set_voltage; it would fail. */ voltage = regulator_get_voltage(supply); - if (mmc->caps2 & MMC_CAP2_BROKEN_VOLTAGE) + if (regulator_count_voltages(supply) == 1) min_uV = max_uV = voltage; if (voltage < 0) -- Chris Ball <cjb@xxxxxxxxxx> <http://printf.net/> One Laptop Per Child -- To unsubscribe from this list: send the line "unsubscribe linux-mmc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
