On Tue, 2022-05-10 at 22:30 -0700, Wei Xu wrote: > On Tue, May 10, 2022 at 4:38 AM Aneesh Kumar K.V > <aneesh.kumar@xxxxxxxxxxxxx> wrote: > > > > Alistair Popple <apopple@xxxxxxxxxx> writes: > > > > > Wei Xu <weixugc@xxxxxxxxxx> writes: > > > > > > > On Thu, May 5, 2022 at 5:19 PM Alistair Popple <apopple@xxxxxxxxxx> wrote: > > > > > > > > > > Wei Xu <weixugc@xxxxxxxxxx> writes: > > > > > > > > > > [...] > > > > > > > > > > > > > > > > > > > > > > > > > > > > > Tiering Hierarchy Initialization > > > > > > > > `==============================' > > > > > > > > > > > > > > > > By default, all memory nodes are in the top tier (N_TOPTIER_MEMORY). > > > > > > > > > > > > > > > > A device driver can remove its memory nodes from the top tier, e.g. > > > > > > > > a dax driver can remove PMEM nodes from the top tier. > > > > > > > > > > > > > > With the topology built by firmware we should not need this. > > > > > > > > > > I agree that in an ideal world the hierarchy should be built by firmware based > > > > > on something like the HMAT. But I also think being able to override this will be > > > > > useful in getting there. Therefore a way of overriding the generated hierarchy > > > > > would be good, either via sysfs or kernel boot parameter if we don't want to > > > > > commit to a particular user interface now. > > > > > > > > > > However I'm less sure letting device-drivers override this is a good idea. How > > > > > for example would a GPU driver make sure it's node is in the top tier? By moving > > > > > every node that the driver does not know about out of N_TOPTIER_MEMORY? That > > > > > could get messy if say there were two drivers both of which wanted their node to > > > > > be in the top tier. > > > > > > > > The suggestion is to allow a device driver to opt out its memory > > > > devices from the top-tier, not the other way around. > > > > > > So how would demotion work in the case of accelerators then? In that > > > case we would want GPU memory to demote to DRAM, but that won't happen > > > if both DRAM and GPU memory are in N_TOPTIER_MEMORY and it seems the > > > only override available with this proposal would move GPU memory into a > > > lower tier, which is the opposite of what's needed there. > > > > How about we do 3 tiers now. dax kmem devices can be registered to > > tier 3. By default all numa nodes can be registered at tier 2 and HBM or > > GPU can be enabled to register at tier 1. ? > > This makes sense. I will send an updated RFC based on the discussions so far. Are these tier number fixed? If so, it appears strange that the smallest tier number is 0 on some machines, but 1 on some other machines. Best Regards, Huang, Ying
