Re: [PATCH] mm: fix race between MADV_FREE reclaim and blkdev direct IO read

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Yang Shi <shy828301@xxxxxxxxx> writes:

> On Fri, Dec 10, 2021 at 6:22 PM Mauricio Faria de Oliveira
> <mfo@xxxxxxxxxxxxx> wrote:
>>
>> Problem:
>> =======
>>
>> Userspace might read the zero-page instead of actual data from a
>> direct IO read on a block device if the buffers have been called
>> madvise(MADV_FREE) on earlier (this is discussed below) due to a
>> race between page reclaim on MADV_FREE and blkdev direct IO read.
>>
>> Race condition:
>> ==============
>>
>> During page reclaim, the MADV_FREE page check in try_to_unmap_one()
>> checks if the page is not dirty, then discards its PTE (vs remap it
>> back if the page is dirty).
>>
>> However, after try_to_unmap_one() returns to shrink_page_list(), it
>> might keep the page _anyway_ if page_ref_freeze() fails (it expects
>> a single page ref from the isolation).
>>
>> Well, blkdev_direct_IO() gets references for all pages, and on READ
>> operations it sets them dirty later.
>>
>> So, if MADV_FREE pages (i.e., not dirty) are used as buffers (more
>> later) for direct IO read from block devices and page reclaim runs
>> during __blkdev_direct_IO[_simple]() AFTER bio_iov_iter_get_pages()
>> but BEFORE it sets pages dirty, that situation happens.
>>
>> The direct IO read eventually completes. Now, when userspace reads
>> the buffers, the PTE is no longer there and the page fault handler
>> do_anonymous_page() services that with the zero-page, NOT the data!
>>
>> A synthetic reproducer is provided.
>>
>> Page faults:
>> ===========
>>
>> The data read from the block device probably won't generate faults
>> due to DMA (no MMU) but even in the case it wouldn't use DMA, that
>> happens on different virtual addresses (not user-mapped addresses)
>> because `struct bio_vec` stores `struct page` to figure addresses
>> out (which are different from/unrelated to user-mapped addresses)
>> for the data read.
>>
>> Thus userspace reads (to user-mapped addresses) still fault, then
>> do_anonymous_page() gets another `struct page` that would address/
>> map to other memory than the `struct page` used by `struct bio_vec`
>> for the read (which runs correctly as the page wasn't freed due to
>> page_ref_freeze(), and is reclaimed later) -- but even if the page
>> addresses matched, that handler maps the zero-page in the PTE, not
>> that page's memory (on read faults.)
>>
>> If page reclaim happens BEFORE bio_iov_iter_get_pages() the issue
>> doesn't happen, because that faults-in all pages as writeable, so
>> do_anonymous_page() sets up a new page/rmap/PTE, and that is used
>> by direct IO. The userspace reads don't fault as the PTE is there
>> (thus zero-page is not used.)
>>
>> Solution:
>> ========
>>
>> One solution is to check for the expected page reference count in
>> try_to_unmap_one() too, which should be exactly two: one from the
>> isolation (checked by shrink_page_list()), and the other from the
>> rmap (dropped by the discard: label). If that doesn't match, then
>> remap the PTE back, just like page dirty does.
>>
>> The new check in try_to_unmap_one() should be safe in races with
>> bio_iov_iter_get_pages() in get_user_pages() fast and slow paths,
>> as it's done under the PTE lock. The fast path doesn't take that
>> lock but it checks the PTE has changed, then drops the reference
>> and leaves the page for the slow path (which does take that lock).
>>
>> - try_to_unmap_one()
>>   - page_vma_mapped_walk()
>>     - map_pte() # see pte_offset_map_lock():
>>         pte_offset_map()
>>         spin_lock()
>>   - page_ref_count() # new check
>>   - page_vma_mapped_walk_done() # see pte_unmap_unlock():
>>       pte_unmap()
>>       spin_unlock()
>>
>> - bio_iov_iter_get_pages()
>>   - __bio_iov_iter_get_pages()
>>     - iov_iter_get_pages()
>>       - get_user_pages_fast()
>>         - internal_get_user_pages_fast()
>>
>>           # fast path
>>           - lockless_pages_from_mm()
>>             - gup_{pgd,p4d,pud,pmd,pte}_range()
>>                 ptep = pte_offset_map() # not _lock()
>>                 pte = ptep_get_lockless(ptep)
>>                 page = pte_page(pte)
>>                 try_grab_compound_head(page) # get ref
>>                 if (pte_val(pte) != pte_val(*ptep))
>>                         put_compound_head(page) # put ref
>>                         # leave page for slow path
>>           # slow path
>>           - __gup_longterm_unlocked()
>>             - get_user_pages_unlocked()
>>               - __get_user_pages_locked()
>>                 - __get_user_pages()
>>                   - follow_{page,p4d,pud,pmd}_mask()
>>                     - follow_page_pte()
>>                         ptep = pte_offset_map_lock()
>>                         pte = *ptep
>>                         page = vm_normal_page(pte)
>>                         try_grab_page(page) # get ref
>>                         pte_unmap_unlock()
>>
>> Regarding transparent hugepages, that number shouldn't change, as
>> MADV_FREE (aka lazyfree) pages are PageAnon() && !PageSwapBacked()
>> (madvise_free_pte_range() -> mark_page_lazyfree() -> lru_lazyfree_fn())
>> thus should reach shrink_page_list() -> split_huge_page_to_list()
>> before try_to_unmap[_one](), so it deals with normal pages only.
>>
>> (And in case unlikely/TTU_SPLIT_HUGE_PMD/split_huge_pmd_address()
>> happens, which it should not or be rare, the page refcount is not
>> two, as the head page counts tail pages, and tail pages have zero.
>> That also prevents checking the head `page` then incorrectly call
>> page_remove_rmap(subpage) for a tail page, that isn't even in the
>> shrink_page_list()'s page_list (an effect of split huge pmd/pmvw),
>> as it might happen today in this unlikely scenario.)
>>
>> MADV_FREE'd buffers:
>> ===================
>>
>> So, back to the "if MADV_FREE pages are used as buffers" note.
>> The case is arguable, and subject to multiple interpretations.
>>
>> The madvise(2) manual page on the MADV_FREE advice value says:
>> - 'After a successful MADV_FREE ... data will be lost when
>>    the kernel frees the pages.'
>> - 'the free operation will be canceled if the caller writes
>>    into the page' / 'subsequent writes ... will succeed and
>>    then [the] kernel cannot free those dirtied pages'
>> - 'If there is no subsequent write, the kernel can free the
>>    pages at any time.'
>>
>> Thoughts, questions, considerations...
>> - Since the kernel didn't actually free the page (page_ref_freeze()
>>   failed), should the data not have been lost? (on userspace read.)
>> - Should writes performed by the direct IO read be able to cancel
>>   the free operation?
>>   - Should the direct IO read be considered as 'the caller' too,
>>     as it's been requested by 'the caller'?
>>   - Should the bio technique to dirty pages on return to userspace
>>     (bio_check_pages_dirty() is called/used by __blkdev_direct_IO())
>>     be considered in another/special way here?
>> - Should an upcoming write from a previously requested direct IO
>>   read be considered as a subsequent write, so the kernel should
>>   not free the pages? (as it's known at the time of page reclaim.)
>>
>> Technically, the last point would seem a reasonable consideration
>> and balance, as the madvise(2) manual page apparently (and fairly)
>> seem to assume that 'writes' are memory access from the userspace
>> process (not explicitly considering writes from the kernel or its
>> corner cases; again, fairly).. plus the kernel fix implementation
>> for the corner case of the largely 'non-atomic write' encompassed
>> by a direct IO read operation, is relatively simple; and it helps.
>>
>> Reproducer:
>> ==========
>>
>> @ test.c (simplified, but works)
>>
>>         #define _GNU_SOURCE
>>         #include <fcntl.h>
>>         #include <stdio.h>
>>         #include <unistd.h>
>>         #include <sys/mman.h>
>>
>>         int main() {
>>                 int fd, i;
>>                 char *buf;
>>
>>                 fd = open(DEV, O_RDONLY | O_DIRECT);
>>
>>                 buf = mmap(NULL, BUF_SIZE, PROT_READ | PROT_WRITE,
>>                            MAP_PRIVATE | MAP_ANONYMOUS, -1, 0);
>>
>>                 for (i = 0; i < BUF_SIZE; i += PAGE_SIZE)
>>                         buf[i] = 1; // init to non-zero
>>
>>                 madvise(buf, BUF_SIZE, MADV_FREE);
>
> IIUC, you are expecting to get the old data after MADV_FREE? TBH, you
> should not expect so at all after MADV_FREE since those pages may get
> freed at any time.
>

Per my understanding, if direct IO reading is done after MADV_FREE, I
think we want to get the new data instead of old data.

Best Regards,
Huang, Ying




[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [IETF Annouce]     [Bugtraq]     [Linux OMAP]     [Linux MIPS]     [eCos]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux