On Wed, 31 Aug 2011 19:13:34 +0900 Minchan Kim <minchan.kim@xxxxxxxxx> wrote: > On Wed, Aug 31, 2011 at 6:08 PM, Johannes Weiner <jweiner@xxxxxxxxxx> wrote: > > Reclaim decides to skip scanning an active list when the corresponding > > inactive list is above a certain size in comparison to leave the > > assumed working set alone while there are still enough reclaim > > candidates around. > > > > The memcg implementation of comparing those lists instead reports > > whether the whole memcg is low on the requested type of inactive > > pages, considering all nodes and zones. > > > > This can lead to an oversized active list not being scanned because of > > the state of the other lists in the memcg, as well as an active list > > being scanned while its corresponding inactive list has enough pages. > > > > Not only is this wrong, it's also a scalability hazard, because the > > global memory state over all nodes and zones has to be gathered for > > each memcg and zone scanned. > > > > Make these calculations purely based on the size of the two LRU lists > > that are actually affected by the outcome of the decision. > > > > Signed-off-by: Johannes Weiner <jweiner@xxxxxxxxxx> > > Cc: Rik van Riel <riel@xxxxxxxxxx> > > Cc: KOSAKI Motohiro <kosaki.motohiro@xxxxxxxxxxxxxx> > > Cc: KAMEZAWA Hiroyuki <kamezawa.hiroyu@xxxxxxxxxxxxxx> > > Cc: Daisuke Nishimura <nishimura@xxxxxxxxxxxxxxxxx> > > Cc: Balbir Singh <bsingharora@xxxxxxxxx> > > Reviewed-by: Minchan Kim <minchan.kim@xxxxxxxxx> > > I can't understand why memcg is designed for considering all nodes and zones. > Is it a mistake or on purpose? It's purpose. memcg just takes care of the amount of pages. Them, any performance numbers ? But, hmm, this change may be good for softlimit and your work. I'll ack when you add performance numbers in changelog. Thanks, -Kame -- To unsubscribe, send a message with 'unsubscribe linux-mm' in the body to majordomo@xxxxxxxxx. For more info on Linux MM, see: http://www.linux-mm.org/ . Fight unfair telecom internet charges in Canada: sign http://stopthemeter.ca/ Don't email: <a href=mailto:"dont@xxxxxxxxx";> email@xxxxxxxxx </a>