On Tue, Oct 31, 2017 at 4:51 PM, Peter Zijlstra <peterz@xxxxxxxxxxxxx> wrote: > On Tue, Oct 31, 2017 at 02:13:33PM +0100, Michal Hocko wrote: >> On Mon 30-10-17 16:10:09, Peter Zijlstra wrote: > >> > However, that splat translates like: >> > >> > __cpuhp_setup_state() >> > #0 cpus_read_lock() >> > __cpuhp_setup_state_cpuslocked() >> > #1 mutex_lock(&cpuhp_state_mutex) >> > >> > >> > >> > __cpuhp_state_add_instance() >> > #2 mutex_lock(&cpuhp_state_mutex) >> >> this should be #1 right? > > Yes > >> > cpuhp_issue_call() >> > cpuhp_invoke_ap_callback() >> > #3 wait_for_completion() >> > >> > msr_device_create() >> > ... >> > #4 filename_create() >> > #3 complete() >> > >> > >> > >> > do_splice() >> > #4 file_start_write() >> > do_splice_from() >> > iter_file_splice_write() >> > #5 pipe_lock() >> > vfs_iter_write() >> > ... >> > #6 inode_lock() >> > >> > >> > >> > sys_fcntl() >> > do_fcntl() >> > shmem_fcntl() >> > #5 inode_lock() > > And that #6 > >> > shmem_wait_for_pins() >> > if (!scan) >> > lru_add_drain_all() >> > #0 cpus_read_lock() >> > >> > >> > >> > Which is an actual real deadlock, there is no mixing of up and down. >> >> thanks a lot, this made it more clear to me. It took a while to >> actually see 0 -> 1 -> 3 -> 4 -> 5 -> 0 cycle. I have only focused >> on lru_add_drain_all while it was holding the cpus lock. > > Yeah, these things are a pain to read, which is why I always construct > something like the above first. I noticed that for a simple 2 lock deadlock lockdep prints only 2 stacks. FWIW in user-space TSAN we print 4 stacks for such deadlocks, namely where A was locked, where B was locked under A, where B was locked, where A was locked under B. It makes it easier to figure out what happens. However, for this report it seems to be 8 stacks this way. So it's probably hard either way. -- To unsubscribe, send a message with 'unsubscribe linux-mm' in the body to majordomo@xxxxxxxxx. For more info on Linux MM, see: http://www.linux-mm.org/ . Don't email: <a href=mailto:"dont@xxxxxxxxx";> email@xxxxxxxxx </a>
