On Wed, Sep 25, 2024 at 10:16:26AM +1200, Chris Packham wrote: > Add device tree schema for the Realtek RTL9300 switches. The RTL9300 > family is made up of the RTL9301, RTL9302B, RTL9302C and RTL9303. These > have the same SoC differ in the Ethernet switch/SERDES arrangement. > > Currently the only supported features are the syscon-reboot and i2c > controllers. The syscon-reboot is needed to be able to reboot the board. > The I2C controllers are slightly unusual because they each own an SCL > pin (GPIO 8 for the first controller, GPIO 17 for the second) but have 8 > common SDA pins which can be assigned to either controller (but not > both). > > Signed-off-by: Chris Packham <chris.packham@xxxxxxxxxxxxxxxxxxx> > --- > > This is my initial attempt at addressing Krzysztof's comments from my two > series. I expect there may still be a bit of discussion on the binding so I'm > just sending this on it's own rather than the whole series. You need to change the reboot binding first, then you add this one (either one or two patches). Best regards, Krzysztof
