On Tue, Aug 01, 2023 at 07:37:37AM +0200, Ladislav Michl wrote:
> Anyway, what about just passing octeon into dwc3_octeon_config_gpio
> and use all that dirty magic inside. Would that work work for you?
Something like this:
[PATCH] usb: dwc3: dwc3-octeon: Consolidate pinmux configuration
As there is no pinctrl driver for Octeon, pinmux configuration is done
in dwc3_octeon_config_gpio function. It has been always done the tricky
way: there are two UCTLs; first at 0x1180068000000 and second at
0x1180069000000, so address based test is used to get index to configure
pin muxing, because DT does not provide that information.
To make pinmux configuration a little less hackish until proper solution
is developed, move all its logic into dwc3_octeon_config_gpio function.
---
drivers/usb/dwc3/dwc3-octeon.c | 7 ++++---
1 file changed, 4 insertions(+), 3 deletions(-)
diff --git a/drivers/usb/dwc3/dwc3-octeon.c b/drivers/usb/dwc3/dwc3-octeon.c
index 90e1ae66769f..f35dca899d6e 100644
--- a/drivers/usb/dwc3/dwc3-octeon.c
+++ b/drivers/usb/dwc3/dwc3-octeon.c
@@ -206,9 +206,10 @@ static inline void dwc3_octeon_writeq(void __iomem *base, uint64_t val)
cvmx_writeq_csr(base, val);
}
-static void dwc3_octeon_config_gpio(int index, int gpio)
+static void dwc3_octeon_config_gpio(struct dwc3_octeon *octeon, int gpio)
{
union cvmx_gpio_bit_cfgx gpio_bit;
+ int index = ((__force uintptr_t)octeon->base >> 24) & 1;
if ((OCTEON_IS_MODEL(OCTEON_CN73XX) ||
OCTEON_IS_MODEL(OCTEON_CNF75XX))
@@ -237,7 +238,7 @@ static inline uint64_t dwc3_octeon_readq(void __iomem *addr)
static inline void dwc3_octeon_writeq(void __iomem *base, uint64_t val) { }
-static inline void dwc3_octeon_config_gpio(int index, int gpio) { }
+static inline void dwc3_octeon_config_gpio(struct dwc3_octeon *octeon, int gpio) { }
static uint64_t octeon_get_io_clock_rate(void)
{
@@ -422,7 +423,7 @@ static int dwc3_octeon_setup(struct dwc3_octeon *octeon,
val &= ~USBDRD_UCTL_HOST_PPC_EN;
} else {
val |= USBDRD_UCTL_HOST_PPC_EN;
- dwc3_octeon_config_gpio(((u64)octeon->base >> 24) & 1, power_gpio);
+ dwc3_octeon_config_gpio(octeon, power_gpio);
dev_dbg(dev, "power control is using gpio%d\n", power_gpio);
}
if (power_active_low)
--
2.39.2
