On 12/10/2014 01:20 PM, Sylwester Nawrocki wrote:
Hi,
On 04/12/14 17:12, Pavel Machek wrote:
+- maxim,boost-mode :
+ In boost mode the device can produce up to 1.2A of total current
+ on both outputs. The maximum current on each output is reduced
+ to 625mA then. If there are two child led nodes defined then boost
+ is enabled by default.
+ Possible values:
+ MAX77693_LED_BOOST_OFF - no boost,
+ MAX77693_LED_BOOST_ADAPTIVE - adaptive mode,
+ MAX77693_LED_BOOST_FIXED - fixed mode.
+- maxim,boost-vout : Output voltage of the boost module in millivolts.
+- maxim,vsys-min : Low input voltage level in millivolts. Flash is not fired
+ if chip estimates that system voltage could drop below this level due
+ to flash power consumption.
+
+Required properties of the LED child node:
+- label : see Documentation/devicetree/bindings/leds/common.txt
+- maxim,fled_id : Identifier of the fled output the led is connected to;
I'm pretty sure this will be needed for about every chip that can drive
multiple LEDs. Shouldn't it be documented in the generic documentation?
OK.
Well... "fled_id" is not exactly suitable name. On other busses, it
would be "reg = <1>"?
I think we need to clarify what the LED device node subnodes really mean.
I thought initially they describe a physical current output of the LED
controller, but it turns out the subnode corresponds to a LED attached
to the LED controller. Since a LED can be connected to multiple outputs
of the LED controller I think 'reg' property doesn't make sense here.
Then presumably we should use a property in each subnode, telling which
LED controller outputs a LED is connected to?
For instance, if we assign numbers 0, 1 to FLED1, FLED2 outputs of
MAX77693 and there is just one LED connected to those outputs we would
have something like:
max77693: led {
compatible = "maxim,max77693-led";
...
led1 {
maxim,fled-sources = <0 1>;
...
};
};
Feel free to propose better name for the property, I guess we need to
avoid "maxim,current-sources" due to ambiguity of the word "current".
For me this sounds reasonable. Moreover we will avoid the need for
address-cells and size-cells properties in the parent node.
Best Regards,
Jacek Anaszewski
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
