Hi! > >>+- maxim,boost-mode : > >>+ In boost mode the device can produce up to 1.2A of total current > >>+ on both outputs. The maximum current on each output is reduced > >>+ to 625mA then. If there are two child led nodes defined then boost > >>+ is enabled by default. > >>+ Possible values: > >>+ MAX77693_LED_BOOST_OFF - no boost, > >>+ MAX77693_LED_BOOST_ADAPTIVE - adaptive mode, > >>+ MAX77693_LED_BOOST_FIXED - fixed mode. > >>+- maxim,boost-vout : Output voltage of the boost module in millivolts. > >>+- maxim,vsys-min : Low input voltage level in millivolts. Flash is not fired > >>+ if chip estimates that system voltage could drop below this level due > >>+ to flash power consumption. > >>+ > >>+Required properties of the LED child node: > >>+- label : see Documentation/devicetree/bindings/leds/common.txt > >>+- maxim,fled_id : Identifier of the fled output the led is connected to; > > > >I'm pretty sure this will be needed for about every chip that can drive > >multiple LEDs. Shouldn't it be documented in the generic documentation? > > OK. Well... "fled_id" is not exactly suitable name. On other busses, it would be "reg = <1>"? Pavel -- (english) http://www.livejournal.com/~pavelmachek (cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
