I added some new parameters as described. Comments are welcome - I haven't got almost any up to date. I will keep latest version of that document same old address: http://palosaari.fi/linux/kernel_sdr_api_requirement_specification.txt regards Antti LINUX KERNEL SDR API REQUIREMENT SPECIFICATION ===================================================================== Ideal SDR specific requirements (basics SDR settings) ********************************************************************* operation mode * values: ADC (Rx) or DAC (Tx) * operations GET, inquire what HW supports GET, get current value SET, set desired value sampling resolution * values: 1 - 32 (unit: bit) 16 bit could be enough, but better to leave some room for future * operations GET, inquire what HW supports GET, get current value SET, set desired value sampling rate * values: 1 - infinity (unit: Hz, symbols per second) currently 500 MHz is more than enough * operations GET, inquire what HW supports GET, get current value SET, set desired value TODO: * inversion? Practical SDR specific requirements (SDR settings for RF tuner) ********************************************************************* RF frequency * values: 1 - infinity (unit: Hz) currently 100 GHz is more than enough * operations GET, inquire what HW supports there could be unsupported ranges between lower and upper freq GET, get current value SET, set desired value IF frequency (intermediate frequency) * values: 0 - infinity (unit: Hz) currently 500 MHz is more than enough * operations GET, get current value tuner lock (frequency synthesizer / PLL) * values: yes/no * operations GET, get current value tuner gains * gain and attenuation * there could be multiple places to adjust gain on tuner signal path * is single overall gain enough or do we want more manual fine tuning? tuner filters * there could be multiple filters on tuner signal path (RF/IF) * do we need to control filters at all? * calculate from sampling rate? TODO: * pass RF standard to tuner? Passing standard is clearly against idea, but some RF tuners does "black magic" according to standard. That magic is usually setting filters and and gains, but it could be more... * inversion? Hardware specific requirements (board settings) ********************************************************************* antenna switch * values: 0 - 32 (unit: piece) * operations GET, inquire what HW supports GET, get current value SET, set desired value external LNA * values: -200000 - 200000 (unit: dB/1000) * operations GET, inquire what HW supports GET, get current value SET, set desired value * range from -200dB to 200dB should be enough multiple ADCs / DACs on single device * there could be multiple ADCs and DACs on single device * resources could be shared which limits concurrent usage * eg. device has 2 ADC + 2 DAC = 4 total, but only 2 could be used at the time Kernel specific requirements ********************************************************************* device locking between multiple APIs * same device could support multiple APIs which could not be used at same time * for example DVB API and V4L2 API * locking needed DOCUMENT VERSION HISTORY ===================================================================== 2012-10-15 Antti Palosaari <crope@xxxxxx> * Initial version 2013-04-11 Antti Palosaari <crope@xxxxxx> * add version history * order requirements per sections * add IF frequency (intermediate frequency) * add tuner lock (frequency synthesizer / PLL) * add external LNA * add TODOs -- http://palosaari.fi/ -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
