On Sábado, 12 de enero de 2013 01:49:21 Antti Palosaari escribió: > On 01/12/2013 01:45 AM, Jose Alberto Reguero wrote: > > On Viernes, 11 de enero de 2013 20:38:01 Antti Palosaari escribió: > >> Hello Jose and Gianluca > >> > >> Could you test that (tda18218 & mxl5007t): > >> http://git.linuxtv.org/anttip/media_tree.git/shortlog/refs/heads/it9135_t > >> une r > >> > >> I wonder if ADC config logic still works for superheterodyne tuners > >> (tuner having IF). I changed it to adc / 2 always due to IT9135 tuner. > >> That makes me wonder it possible breaks tuners having IF, as ADC was > >> clocked just over 20MHz and if it is half then it is 10MHz. For BB that > >> is enough, but I think that having IF, which is 4MHz at least for 8MHz > >> BW it is too less. > >> > >> F*ck I hate to maintain driver without a hardware! Any idea where I can > >> get AF9035 device having tda18218 or mxl5007t? > >> > >> regards > >> Antti > > > > Still pending the changes for mxl5007t. Attached is a patch for that. > > > > Changes to make work Avermedia Twinstar with the af9035 driver. > > > > Signed-off-by: Jose Alberto Reguero <jareguero@xxxxxxxxxxxxxx> > > I cannot do much about this as it changes mxl5007t driver which is not > maintained by me. :) > > regards > Antti > Adding CC to Michael Krufky because it is the maintainer of mxl5007t driver. Michael, any chance to get this patch merged? Jose Alberto > > Jose Alberto > > > > diff -upr linux/drivers/media/tuners/mxl5007t.c > > linux.new/drivers/media/tuners/mxl5007t.c > > --- linux/drivers/media/tuners/mxl5007t.c 2012-08-14 05:45:22.000000000 > > +0200 +++ linux.new/drivers/media/tuners/mxl5007t.c 2013-01-10 > > 19:23:09.247556275 +0100 > > @@ -374,7 +374,6 @@ static struct reg_pair_t *mxl5007t_calc_ > > > > mxl5007t_set_if_freq_bits(state, cfg->if_freq_hz, cfg->invert_if); > > mxl5007t_set_xtal_freq_bits(state, cfg->xtal_freq_hz); > > > > - set_reg_bits(state->tab_init, 0x04, 0x01, cfg->loop_thru_enable); > > > > set_reg_bits(state->tab_init, 0x03, 0x08, cfg->clk_out_enable << 3); > > set_reg_bits(state->tab_init, 0x03, 0x07, cfg->clk_out_amp); > > > > @@ -531,9 +530,12 @@ static int mxl5007t_tuner_init(struct mx > > > > struct reg_pair_t *init_regs; > > int ret; > > > > - ret = mxl5007t_soft_reset(state); > > - if (mxl_fail(ret)) > > + if (!state->config->no_reset) { > > + ret = mxl5007t_soft_reset(state); > > + if (mxl_fail(ret)) > > > > goto fail; > > > > + } > > + > > > > /* calculate initialization reg array */ > > init_regs = mxl5007t_calc_init_regs(state, mode); > > > > @@ -887,7 +889,12 @@ struct dvb_frontend *mxl5007t_attach(str > > > > if (fe->ops.i2c_gate_ctrl) > > > > fe->ops.i2c_gate_ctrl(fe, 1); > > > > - ret = mxl5007t_get_chip_id(state); > > + if (!state->config->no_probe) > > + ret = mxl5007t_get_chip_id(state); > > + > > + ret = mxl5007t_write_reg(state, 0x04, > > + state->config->loop_thru_enable); > > + > > > > if (fe->ops.i2c_gate_ctrl) > > > > fe->ops.i2c_gate_ctrl(fe, 0); > > > > diff -upr linux/drivers/media/tuners/mxl5007t.h > > linux.new/drivers/media/tuners/mxl5007t.h > > --- linux/drivers/media/tuners/mxl5007t.h 2012-08-14 05:45:22.000000000 > > +0200 +++ linux.new/drivers/media/tuners/mxl5007t.h 2013-01-10 > > 19:19:11.204379581 +0100 > > @@ -73,8 +73,10 @@ struct mxl5007t_config { > > > > enum mxl5007t_xtal_freq xtal_freq_hz; > > enum mxl5007t_if_freq if_freq_hz; > > unsigned int invert_if:1; > > > > - unsigned int loop_thru_enable:1; > > + unsigned int loop_thru_enable:3; > > > > unsigned int clk_out_enable:1; > > > > + unsigned int no_probe:1; > > + unsigned int no_reset:1; > > > > }; > > > > #if defined(CONFIG_MEDIA_TUNER_MXL5007T) || > > > > (defined(CONFIG_MEDIA_TUNER_MXL5007T_MODULE) && defined(MODULE)) > > diff -upr linux/drivers/media/usb/dvb-usb-v2/af9035.c > > linux.new/drivers/media/usb/dvb-usb-v2/af9035.c > > --- linux/drivers/media/usb/dvb-usb-v2/af9035.c 2013-01-07 > > 05:45:57.000000000 +0100 > > +++ linux.new/drivers/media/usb/dvb-usb-v2/af9035.c 2013-01-12 > > 00:30:57.557310465 +0100 > > @@ -886,13 +886,17 @@ static struct mxl5007t_config af9035_mxl > > > > .loop_thru_enable = 0, > > .clk_out_enable = 0, > > .clk_out_amp = MxL_CLKOUT_AMP_0_94V, > > > > + .no_probe = 1, > > + .no_reset = 1, > > > > }, { > > > > .xtal_freq_hz = MxL_XTAL_24_MHZ, > > .if_freq_hz = MxL_IF_4_57_MHZ, > > .invert_if = 0, > > > > - .loop_thru_enable = 1, > > + .loop_thru_enable = 3, > > > > .clk_out_enable = 1, > > .clk_out_amp = MxL_CLKOUT_AMP_0_94V, > > > > + .no_probe = 1, > > + .no_reset = 1, > > > > } > > > > }; -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
