Re: problems with using the -rc kernel in the git tree

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Sun, Dec 19, 2010 at 6:56 PM, Theodore Kilgore
<kilgota@xxxxxxxxxxxxxxxxxxxxxx> wrote:
>
> Hans,
>
> Thanks for the helpful advice about how to set up a git tree for current
> development so that I can get back into things.
>
> However, there is a problem with that -rc kernel, at least as far as my
> hardware is concerned. So if I am supposed to use it to work on camera
> stuff there is an obstacle.
>
> I started by copying my .config file over to the tree, and then running
> make oldconfig (as you said and as I would have done anyway).
>
> The problem seems to be centered right here (couple of lines
> from .config follow)
>
> CONFIG_DRM_RADEON=m
> # CONFIG_DRM_RADEON_KMS is not set
>
> I have a Radeon video card, obviously. Specifically, it is (extract from X
> config file follows)
>
> # Device configured by xorgconfig:
>
> Section "Device"
>    Identifier  "ATI Radeon HD 3200"
>    Driver      "radeon"
>
> Now, what happens is that with the kernel configuration (see above) I
> cannot start X in the -rc kernel. I get bumped out with an error
> message (details below) whereas that _was_ my previous configuration
> setting.
>
> But if in the config for the -rc kernel I change the second line by
> turning on CONFIG_DRM_RADEON_KMS the situation is even worse. Namely, the
> video cuts off during the boot process, with the monitor going blank and
> flashing up a message that it lost signal. After that the only thing to do
> is a hard reset, which strangely does not result in any check for a dirty
> file system, showing that things _really_ got screwed. These problems wit
> the video cutting off at boot are with booting into the _terminal_, BTW. I
> do not and never have made a practice of booting into X. I start X from
> the command line after boot. Thus, the video cutting off during boot has
> nothing to do with X at all, AFAICT.
>
> So as I said there are two alternatives, both of them quite unpleasant.
>
> Here is what the crash message is on the screen from the attempt to start
> up X, followed by what seem to be the relevant lines from the log file,
> with slightly more detail.
>
> Markers: (--) probed, (**) from config file, (==) default setting,
>        (++) from command line, (!!) notice, (II) informational,
>        (WW) warning, (EE) error, (NI) not implemented, (??) unknown.
> (==) Log file: "/var/log/Xorg.0.log", Time: Sun Dec 19 14:32:12 2010
> (==) Using config file: "/etc/X11/xorg.conf"
> (==) Using system config directory "/usr/share/X11/xorg.conf.d"
> (II) [KMS] drm report modesetting isn't supported.
> (EE) RADEON(0): Unable to map MMIO aperture. Invalid argument (22)
> (EE) RADEON(0): Memory map the MMIO region failed
> (EE) Screen(s) found, but none have a usable configuration.
>
> Fatal server error:
> no screens found
>
> Please consult the The X.Org Foundation support
>         at http://wiki.x.org
>  for help.
> Please also check the log file at "/var/log/Xorg.0.log" for additional
> information.
>
> xinit: giving up
> xinit: unable to connect to X server: Connection refused
> xinit: server error
> xinit: unable to connect to X server: Connection refused
> xinit: server error
> kilgota@khayyam:~$
>
> And the following, too, from the log file, which perhaps contains one or
> two
> more details:
>
> [    48.050] (--) using VT number 7
>
> [    48.052] (II) [KMS] drm report modesetting isn't supported.
> [    48.052] (II) RADEON(0): TOTO SAYS 00000000feaf0000
> [    48.052] (II) RADEON(0): MMIO registers at 0x00000000feaf0000: size
> 64KB
> [    48.052] (EE) RADEON(0): Unable to map MMIO aperture. Invalid argument
> (22)
> [    48.052] (EE) RADEON(0): Memory map the MMIO region failed
> [    48.052] (II) UnloadModule: "radeon"
> [    48.052] (EE) Screen(s) found, but none have a usable configuration.
> [    48.052]
> Fatal server error:
> [    48.052] no screens found
> [    48.052]
>
> There are a couple of suggestions about things to try, such as compiling
> with CONFIG_DRM_RADEON_KMS and then passing the parameter modeset=0 to the
> radeon module. But that does not seem to help, either.
>
> The help screens in make menuconfig do not seem to praise the
> CONFIG_DRM_RADEON_KMS very highly, and seem to indicate that this is still
> a very experimental feature.
>
> There are no such equivalent problems with my current kernel, which is a
> home-compiled 2.6.35.7.
>
> I realize that this is a done decision, but it is exactly this kind of
> thing that I had in mind when we had the Great Debate on the linux-media
> list about whether to use hg or git. My position was to let hardware
> support people to run hg with the compatibility layer for recent kernels
> (and 2.6.35.7 is certainly recent!). Well, the people who had such a
> position did not win. So now here is unfortunately the foreseeable result.
> An experimental kernel with some totally unrelated bug which affects my
> hardware and meanwhile stops all progress.

If you enable radeon KMS, you need to enable fbcon in your kernel or
you will lose video when the radeon kms driver loads since it controls
the video device and provide a legacy kernel fbdev interface.  As for
X, you need a ddx (xf86-video-ati) built with kms support (6.13.x
series).

Alex

>
>
> Theodore Kilgore
> --
> To unsubscribe from this list: send the line "unsubscribe linux-media" in
> the body of a message to majordomo@xxxxxxxxxxxxxxx
> More majordomo info at  http://vger.kernel.org/majordomo-info.html
>
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html


[Index of Archives]     [Linux Input]     [Video for Linux]     [Gstreamer Embedded]     [Mplayer Users]     [Linux USB Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [Yosemite Backpacking]
  Powered by Linux