Re: [PATCH v4 3/7] i2c: qcom-cci: Stop complaining about DT set clock rate

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 5.09.2024 4:18 PM, Vladimir Zapolskiy wrote:
> Hi Konrad,
> 
> On 9/5/24 16:57, Konrad Dybcio wrote:
>> On 4.09.2024 4:04 AM, Richard Acayan wrote:
>>> From: Bryan O'Donoghue <bryan.odonoghue@xxxxxxxxxx>
>>>
>>> It is common practice in the downstream and upstream CCI dt to set CCI
>>> clock rates to 19.2 MHz. It appears to be fairly common for initial code to
>>> set the CCI clock rate to 37.5 MHz.
>>>
>>> Applying the widely used CCI clock rates from downstream ought not to cause
>>> warning messages in the upstream kernel where our general policy is to
>>> usually copy downstream hardware clock rates across the range of Qualcomm
>>> drivers.
>>>
>>> Drop the warning it is pervasive across CAMSS users but doesn't add any
>>> information or warrant any changes to the DT to align the DT clock rate to
>>> the bootloader clock rate.
>>>
>>> Signed-off-by: Bryan O'Donoghue <bryan.odonoghue@xxxxxxxxxx>
>>> Reviewed-by: Vladimir Zapolskiy <vladimir.zapolskiy@xxxxxxxxxx>
>>> Link: https://lore.kernel.org/linux-arm-msm/20240824115900.40702-1-bryan.odonoghue@xxxxxxxxxx
>>> Signed-off-by: Richard Acayan <mailingradian@xxxxxxxxx>
>>> ---
>>
>> I.. am not sure this is really a problem? On some platforms the core
>> clock is only 19.2 Mhz, but e.g. on sdm845 we have:
>>
>> static const struct freq_tbl ftbl_cam_cc_cci_clk_src[] = {
>>          F(19200000, P_BI_TCXO, 1, 0, 0),
>>          F(37500000, P_CAM_CC_PLL0_OUT_EVEN, 16, 0, 0),
>>          F(50000000, P_CAM_CC_PLL0_OUT_EVEN, 12, 0, 0),
>>          F(100000000, P_CAM_CC_PLL0_OUT_EVEN, 6, 0, 0),
>>          { }
>> };
>>
>> Shouldn't this be somehow dynamically calculated?
>>
> 
> I believe the problem fixed by the change is an unnecessary dev_warn(), in
> addition it's unclear why the CCI clock rate shall be strictly 37500000 for
> all "CCI v2" platforms.
> 
> If the latter is a necessity, then it would be better to set the rate
> explicitly, however since it's not done for any such platforms, I would say
> that it is not needed.
> 
> And if it is not needed, or a default and universal 19.2MHz rate is good
> enough, then I would suggest to remove everything 'cci_clk_rate' related
> from the driver, and this makes the change incomplete...

Downstream seems to set 37500000 for all SoCs with Titan.. but I can't
find a good reason for this.. I'll try to get some answers.

Konrad




[Index of Archives]     [Linux Input]     [Video for Linux]     [Gstreamer Embedded]     [Mplayer Users]     [Linux USB Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [Yosemite Backpacking]

  Powered by Linux