Hi,
On Wed, Apr 03, 2024 at 04:28:59PM GMT, Sakari Ailus wrote:
> Hi Luis,
>
> Could you unify the subject prefix for the driver patches, please? E.g.
> "media: imx258: " would be fine.
>
> On Wed, Apr 03, 2024 at 09:03:53AM -0600, git@xxxxxxxxxxxx wrote:
> > From: Luis Garcia <git@xxxxxxxxxxxx>
> >
> > It was documented in DT, but not implemented.
> >
> > Signed-off-by: Ondrej Jirman <megous@xxxxxxxxxx>
> > Signed-off-by: Luis Garcia <git@xxxxxxxxxxxx>
> > ---
> > drivers/media/i2c/imx258.c | 14 +++++++++++++-
> > 1 file changed, 13 insertions(+), 1 deletion(-)
> >
> > diff --git a/drivers/media/i2c/imx258.c b/drivers/media/i2c/imx258.c
> > index 163f04f6f954..4c117c4829f1 100644
> > --- a/drivers/media/i2c/imx258.c
> > +++ b/drivers/media/i2c/imx258.c
> > @@ -680,6 +680,7 @@ struct imx258 {
> > unsigned int csi2_flags;
> >
> > struct gpio_desc *powerdown_gpio;
> > + struct gpio_desc *reset_gpio;
> >
> > /*
> > * Mutex for serialized access:
> > @@ -1232,7 +1233,11 @@ static int imx258_power_on(struct device *dev)
> > regulator_bulk_disable(IMX258_NUM_SUPPLIES, imx258->supplies);
> > }
> >
> > - return ret;
> > + gpiod_set_value_cansleep(imx258->reset_gpio, 0);
> > +
> > + usleep_range(400, 500);
>
> You could mention this at least in the commit message.
This is T6 in the datasheet: https://megous.com/dl/tmp/92c9223ce877216e.png
> > +
> > + return 0;
> > }
> >
> > static int imx258_power_off(struct device *dev)
> > @@ -1243,6 +1248,7 @@ static int imx258_power_off(struct device *dev)
> > clk_disable_unprepare(imx258->clk);
> > regulator_bulk_disable(IMX258_NUM_SUPPLIES, imx258->supplies);
> >
> > + gpiod_set_value_cansleep(imx258->reset_gpio, 1);
>
> Same question than on the other GPIO: does this belong here?
No, this should be before the regulator_bulk_disable.
See: https://megous.com/dl/tmp/c96180b23d7ce63a.png
kind regards,
o.
> > gpiod_set_value_cansleep(imx258->powerdown_gpio, 1);
> >
> > return 0;
> > @@ -1554,6 +1560,12 @@ static int imx258_probe(struct i2c_client *client)
> > if (IS_ERR(imx258->powerdown_gpio))
> > return PTR_ERR(imx258->powerdown_gpio);
> >
> > + /* request optional reset pin */
> > + imx258->reset_gpio = devm_gpiod_get_optional(&client->dev, "reset",
> > + GPIOD_OUT_HIGH);
> > + if (IS_ERR(imx258->reset_gpio))
> > + return PTR_ERR(imx258->reset_gpio);
> > +
> > /* Initialize subdev */
> > v4l2_i2c_subdev_init(&imx258->sd, client, &imx258_subdev_ops);
> >
>
> --
> Regards,
>
> Sakari Ailus
