Hi Bryan,
On 14/08/2023 16:10, Bryan O'Donoghue wrote:
> VC_MODE = 0 implies a two bit VC address.
> VC_MODE = 1 is required for VCs with a larger address than two bits.
This explains the second chunk in the patch below, but it doesn't explain
why dt_id is now suddenly vc * 4 instead of vc.
I don't feel comfortable merging this patch since I'm not sure if that
dt_id change was perhaps an error.
If the change IS correct, then please reply and provide a better commit
log.
Regards,
Hans
>
> Fixes: eebe6d00e9bf ("media: camss: Add support for CSID hardware version Titan 170")
> Cc: stable@xxxxxxxxxxxxxxx
> Signed-off-by: Bryan O'Donoghue <bryan.odonoghue@xxxxxxxxxx>
> ---
> drivers/media/platform/qcom/camss/camss-csid-gen2.c | 4 +++-
> 1 file changed, 3 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/media/platform/qcom/camss/camss-csid-gen2.c b/drivers/media/platform/qcom/camss/camss-csid-gen2.c
> index 45c7986d4a8d0..9ac253111e572 100644
> --- a/drivers/media/platform/qcom/camss/camss-csid-gen2.c
> +++ b/drivers/media/platform/qcom/camss/camss-csid-gen2.c
> @@ -352,7 +352,7 @@ static void __csid_configure_stream(struct csid_device *csid, u8 enable, u8 vc)
> phy_sel = csid->phy.csiphy_id;
>
> if (enable) {
> - u8 dt_id = vc;
> + u8 dt_id = vc * 4;
>
> if (tg->enabled) {
> /* Config Test Generator */
> @@ -449,6 +449,8 @@ static void __csid_configure_stream(struct csid_device *csid, u8 enable, u8 vc)
> writel_relaxed(val, csid->base + CSID_CSI2_RX_CFG0);
>
> val = 1 << CSI2_RX_CFG1_PACKET_ECC_CORRECTION_EN;
> + if (vc > 3)
> + val |= 1 << CSI2_RX_CFG1_VC_MODE;
> val |= 1 << CSI2_RX_CFG1_MISR_EN;
> writel_relaxed(val, csid->base + CSID_CSI2_RX_CFG1);
>
