Fix AV1 decoding failure when the iova is 36bit.
Before this fix, the decoder was accessing incorrect addresses with 36bit
iova tile buffer, leading to iommu faults.
Fixes: 2f5d0aef37c6 ("media: mediatek: vcodec: support stateless AV1 decoder")
Signed-off-by: Xiaoyong Lu<xiaoyong.lu@xxxxxxxxxxxx>
---
Changes from v2:
- refine commit subject and message
Changes from v1:
- prefer '|' rather than '+'
- prefer '&' rather than shift operation
- add comments for address operations
v1:
- VDEC HW can access tile buffer and decode normally.
- Test ok by mt8195 32bit and mt8188 36bit iova.
---
.../mediatek/vcodec/vdec/vdec_av1_req_lat_if.c | 12 ++++++++----
1 file changed, 8 insertions(+), 4 deletions(-)
diff --git a/drivers/media/platform/mediatek/vcodec/vdec/vdec_av1_req_lat_if.c b/drivers/media/platform/mediatek/vcodec/vdec/vdec_av1_req_lat_if.c
index 404a1a23fd402..e9f2393f6a883 100644
--- a/drivers/media/platform/mediatek/vcodec/vdec/vdec_av1_req_lat_if.c
+++ b/drivers/media/platform/mediatek/vcodec/vdec/vdec_av1_req_lat_if.c
@@ -1658,9 +1658,9 @@ static void vdec_av1_slice_setup_tile_buffer(struct vdec_av1_slice_instance *ins
u32 allow_update_cdf = 0;
u32 sb_boundary_x_m1 = 0, sb_boundary_y_m1 = 0;
int tile_info_base;
- u32 tile_buf_pa;
+ u64 tile_buf_pa;
u32 *tile_info_buf = instance->tile.va;
- u32 pa = (u32)bs->dma_addr;
+ u64 pa = (u64)bs->dma_addr;
if (uh->disable_cdf_update == 0)
allow_update_cdf = 1;
@@ -1673,8 +1673,12 @@ static void vdec_av1_slice_setup_tile_buffer(struct vdec_av1_slice_instance *ins
tile_info_buf[tile_info_base + 0] = (tile_group->tile_size[tile_num] << 3);
tile_buf_pa = pa + tile_group->tile_start_offset[tile_num];
- tile_info_buf[tile_info_base + 1] = (tile_buf_pa >> 4) << 4;
- tile_info_buf[tile_info_base + 2] = (tile_buf_pa % 16) << 3;
+ /* save av1 tile high 4bits(bit 32-35) address in lower 4 bits position
+ * and clear original for hw requirement.
+ */
+ tile_info_buf[tile_info_base + 1] = (tile_buf_pa & 0xFFFFFFF0ull) |
+ ((tile_buf_pa & 0xF00000000ull) >> 32);
+ tile_info_buf[tile_info_base + 2] = (tile_buf_pa & 0xFull) << 3;
sb_boundary_x_m1 =
(tile->mi_col_starts[tile_col + 1] - tile->mi_col_starts[tile_col] - 1) &
--
2.18.0
