Currently the imx258 driver requires to have the 'rotation' device node property specified in DTS with a fixed value of 180 degrees. The "rotation" fwnode device property is intended to allow specify the sensor's physical mounting rotation, so that it can be exposed through the read-only V4L2_CID_CAMERA_SENSOR_ROTATION control and applications can decide how to compensate for that. The imx258 driver has read-only VFLIP and HFLIP enabled, resulting in a 180 degrees image rotation being produced by the sensor. But this doesn't imply that the physical mounting rotation should match the driver's implementation. I took into the series Robert's patch that register device node properties and on top of that register flips controls, in order to remove the hard requirement of the 180 degrees rotation property presence. Jacopo Mondi (2): media: imx258: Register H/V flip controls media: imx258: Remove mandatory 180 degrees rotation Robert Mader (1): media: imx258: Parse and register properties drivers/media/i2c/imx258.c | 33 ++++++++++++++++++++++++--------- 1 file changed, 24 insertions(+), 9 deletions(-) -- 2.39.0
