On 22-11-28 12:45:32, Kieran Bingham wrote: > Hi Petko, > > What device/ISP are you testing this sensor on? I'll tell you, but only if you promise to not laugh too much. Deal? i.MX8M-Mini I hope nobody will notice the above line... > Quoting Petko Manolov (2022-11-25 15:31:15) > > This patch adds dt-bindings documentation, driver source, etc for Sony imx492 > > image sensor. > > > > imx492 is a diagonal 23.1 mm (Type 1.4) CMOS image sensor with color or > > monochrome square pixel array and approximately 47.08 M effective pixels. 12-bit > > digital output makes it possible to output the signals with high definition for > > moving pictures. It is programmable through I2C interface. The I2C client > > address can be either 0x10 or 0x1a depending on SLASEL pin. Image data is sent > > through MIPI CSI-2. > > > > Petko Manolov (5): > > DT bindings for imx492 > > media: i2c: imx492: driver's header > > media: i2c: imx492: driver's source > > media: i2c: add imx492 config entry > > media: i2c: add imx492 entry for make > > Could you squash patches 2, 3, 4, and 5 into a single patch please? This is the exact opposite to what the networking folks would prefer, but it's OK with me. > Also - I think you'll need an entry in MAINTAINERS. Right, that one too. > I can't see any reference to the selection controls: > - V4L2_SEL_TGT_CROP_DEFAULT > - V4L2_SEL_TGT_CROP > - V4L2_SEL_TGT_CROP_BOUNDS These are in a very early phase of implementing. > Do you have the datasheet or sufficient information to be able to implement > these controls? Of course not. We are brute forcing our way forward by mostly reverse engineering another solution that has an FPGA on the other end of the CSI link. > -- > Kieran > > > .../bindings/media/i2c/sony,imx492.yaml | 101 ++ > > drivers/media/i2c/Kconfig | 14 + > > drivers/media/i2c/Makefile | 1 + > > drivers/media/i2c/imx492.c | 1092 +++++++++++++++++ > > drivers/media/i2c/imx492.h | 555 +++++++++ > > 5 files changed, 1763 insertions(+) > > create mode 100644 Documentation/devicetree/bindings/media/i2c/sony,imx492.yaml > > create mode 100644 drivers/media/i2c/imx492.c > > create mode 100644 drivers/media/i2c/imx492.h > > > > -- > > 2.30.2 > > Petko