Hi Kate,
On Mon, Mar 14, 2022 at 06:15:22PM +0800, Kate Hsuan wrote:
> For the AF configuration, if the rightmost stripe is used, the AF scene
> will be at the incorrect location of the sensor.
>
> The AF coordinate may be set to the right part of the sensor. This
> configuration would lead to x_start being greater than the
> down_scaled_stripes offset and the leftmost stripe would be disabled
> and only the rightmost stripe is used to control the AF coordinate. If
> the x_start doesn't perform any adjustments, the AF coordinate will be
> at the wrong place of the sensor since down_scaled_stripes offset
> would be the new zero of the coordinate system.
>
> In this patch, if only the rightmost stripe is used, x_start should
> minus down_scaled_stripes offset to maintain its correctness of AF
> scene coordinate.
>
> Changes in v2:
> 1. Remove the setting of the first stripe.
>
> Signed-off-by: Kate Hsuan <hpa@xxxxxxxxxx>
> ---
> drivers/staging/media/ipu3/ipu3-css-params.c | 4 ++++
> 1 file changed, 4 insertions(+)
>
> diff --git a/drivers/staging/media/ipu3/ipu3-css-params.c b/drivers/staging/media/ipu3/ipu3-css-params.c
> index d9e3c3785075..5a8c07f34756 100644
> --- a/drivers/staging/media/ipu3/ipu3-css-params.c
> +++ b/drivers/staging/media/ipu3/ipu3-css-params.c
> @@ -2556,6 +2556,10 @@ int imgu_css_cfg_acc(struct imgu_css *css, unsigned int pipe,
> /* Enable only for rightmost stripe, disable left */
> acc->af.stripes[0].grid_cfg.y_start &=
> ~IPU3_UAPI_GRID_Y_START_EN;
> + acc->af.stripes[1].grid_cfg.x_start -=
> + acc->stripe.down_scaled_stripes[1].offset;
> + acc->af.stripes[1].grid_cfg.x_end -=
> + acc->stripe.down_scaled_stripes[1].offset;
Could you calculate the values the same way as for the two stripes case, as
I've been asking since v1?
> } else if (acc->af.config.grid_cfg.x_end <=
> acc->stripe.bds_out_stripes[0].width - min_overlap) {
> /* Enable only for leftmost stripe, disable right */
--
Regards,
Sakari Ailus
