Hi Anthony, Em Thu, 30 Sep 2021 15:51:22 +0200 Debucquoy Anthony <d.tonitch@xxxxxxxxx> escreveu: > Hello, > > I have currently have a (Grabster AV 350) > [https://www.terratec.de/details.php?artnr=10599&lang=en] > (and 300 that work even less but I will do another thread for it I think) > > I can easily get video output out of it with /dev/video0 but the problem > is that I can't get audio by any way ... > [ 7275.368159 ] em28xx 1-8:1.0: Identified as Terratec AV350 (card=68) > [ 7275.368163 ] em28xx 1-8:1.0: analog set to isoc mode. > [ 7275.368192 ] em28xx 1-8:1.0: Registering V4L2 extension > [ 7275.497387 ] tvp5150 9-005c: tvp5150 (4.0) chip found @ 0xb8 (1-8:1.0) > [ 7275.497396 ] tvp5150 9-005c: tvp5150am1 detected. > [ 7278.429769 ] em28xx 1-8:1.0: Config register raw data: 0x50 > [ 7278.470775 ] em28xx 1-8:1.0: AC97 vendor ID = 0x83847666 > [ 7278.490776 ] em28xx 1-8:1.0: AC97 features = 0x6a90 > [ 7278.490782 ] em28xx 1-8:1.0: Sigmatel audio processor detected (stac > 9766) The em28xx devices use an external chip for audio, using AC97. As AC97 is an industry standard, it is possible for board vendors to replace it with different chips. They do that with time, selecting a different chip when they need/want. The boards entry at the em28xx has configurations for the device that was used at the time the code was introduced, but this may not be the case anymore for a newer device. Anyway, the AC97 chips have several different entries. From its datasheet: https://www.digchip.com/datasheets/parts/datasheet/649/STAC9766-pdf.php It sees that it has the following input lines: pc beep phone aux video cd mic line in They also have a "Master" volume that the driver sets to be in 100% (but some apps and pulseaudio might reduce it to 0%, causing the device to be muted). Anyway, the AC97 Kernel support will expose all lines reported by the hardware via an ALSA mixer. The AV 350 entry assumes that the "line in" mixer entry is the one containing the audio. So, it will place the volume for such line in 100%. However, maybe, on your device, some other input was used instead. If this is the case, all you need to do is to open a mixer, unmute the right line and manually increase the volume. - There's a separate issue that might explain why some people are using a different card: some boards require a command to enable some pins (called GPIO). Those are used, among other things, to enable/disable some external chips. In the case of the original AV 350 that was used to add support for it, it used some of those GPIOs to enable the AC97 inputs. If your AV 350 requires a different setting, that will require to patch the Kernel, but it is more likely that the problem on your device is just due to a different AC97 volume. Thanks, Mauro
