The VNCSI_IFMD register controls the data expansion mode and the
channel routing between the CSI-2 receivers and VIN instances.
According to the chip manual revision 2.20 not all fields are available
for all the SoCs:
- V3M, V3H and E3 do not support the DES1 field has they do not feature
a CSI20 receiver.
- D3 only supports parallel input, and the whole register shall always
be written as 0.
Inspect the per-SoC channel routing table where the available CSI-2
instances are reported and configure VNCSI_IFMD accordingly.
This patch upports the BSP change commit f54697394457
("media: rcar-vin: Fix VnCSI_IFMD register access for r8a77990")
Reviewed-by: Niklas Söderlund <niklas.soderlund+renesas@xxxxxxxxxxxx>
Suggested-by: Niklas Söderlund <niklas.soderlund+renesas@xxxxxxxxxxxx>
Signed-off-by: Jacopo Mondi <jacopo+renesas@xxxxxxxxxx>
---
drivers/media/platform/rcar-vin/rcar-dma.c | 25 +++++++++++++++++++---
1 file changed, 22 insertions(+), 3 deletions(-)
diff --git a/drivers/media/platform/rcar-vin/rcar-dma.c b/drivers/media/platform/rcar-vin/rcar-dma.c
index 378514a75bc2..6397eea665d1 100644
--- a/drivers/media/platform/rcar-vin/rcar-dma.c
+++ b/drivers/media/platform/rcar-vin/rcar-dma.c
@@ -1570,7 +1570,9 @@ int rvin_dma_register(struct rvin_dev *vin, int irq)
*/
int rvin_set_channel_routing(struct rvin_dev *vin, u8 chsel)
{
- u32 ifmd, vnmc;
+ const struct rvin_group_route *route;
+ u32 ifmd = 0;
+ u32 vnmc;
int ret;
ret = pm_runtime_get_sync(vin->dev);
@@ -1583,9 +1585,26 @@ int rvin_set_channel_routing(struct rvin_dev *vin, u8 chsel)
vnmc = rvin_read(vin, VNMC_REG);
rvin_write(vin, vnmc & ~VNMC_VUP, VNMC_REG);
- ifmd = VNCSI_IFMD_DES1 | VNCSI_IFMD_DES0 | VNCSI_IFMD_CSI_CHSEL(chsel);
+ /*
+ * Set data expansion mode to "pad with 0s" by inspecting the routes
+ * table to find out which bit fields are available in the IFMD
+ * register. IFMD_DES1 controls data expansion mode for CSI20/21,
+ * IFMD_DES0 controls data expansion mode for CSI40/41.
+ */
+ for (route = vin->info->routes; route->mask; route++) {
+ if (route->csi == RVIN_CSI20 || route->csi == RVIN_CSI21)
+ ifmd |= VNCSI_IFMD_DES1;
+ else
+ ifmd |= VNCSI_IFMD_DES0;
+
+ if (ifmd == (VNCSI_IFMD_DES0 | VNCSI_IFMD_DES1))
+ break;
+ }
- rvin_write(vin, ifmd, VNCSI_IFMD_REG);
+ if (ifmd) {
+ ifmd |= VNCSI_IFMD_CSI_CHSEL(chsel);
+ rvin_write(vin, ifmd, VNCSI_IFMD_REG);
+ }
vin_dbg(vin, "Set IFMD 0x%x\n", ifmd);
--
2.29.1
