Improve the documentation by specifying that the instructions are related to the i.MX6Q sabreauto variant. This avoids confusion if someone follows these steps on a i.MX6DL sabreauto, which has different numbering on the I2C bus and I2C muxes. Signed-off-by: Fabio Estevam <festevam@xxxxxxxxx> Acked-by: Steve Longerbeam <slongerbeam@xxxxxxxxx> --- Changes since v2: - None Documentation/media/v4l-drivers/imx.rst | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) diff --git a/Documentation/media/v4l-drivers/imx.rst b/Documentation/media/v4l-drivers/imx.rst index 1d7eb8c7bd5c..3d72e411b93d 100644 --- a/Documentation/media/v4l-drivers/imx.rst +++ b/Documentation/media/v4l-drivers/imx.rst @@ -515,10 +515,10 @@ Streaming can then begin independently on the capture device nodes be used to select any supported YUV pixelformat on the capture device nodes, including planar. -SabreAuto with ADV7180 decoder ------------------------------- +i.MX6Q SabreAuto with ADV7180 decoder +------------------------------------- -On the SabreAuto, an on-board ADV7180 SD decoder is connected to the +On the i.MX6Q SabreAuto, an on-board ADV7180 SD decoder is connected to the parallel bus input on the internal video mux to IPU1 CSI0. The following example configures a pipeline to capture from the ADV7180 -- 2.17.1
