Benoit Parrot <bparrot@xxxxxx> wrote on Tue [2017-Sep-12 13:23:39 -0500]:
<snip>
> > +static int csi2rx_start(struct csi2rx_priv *csi2rx)
> > +{
> > + unsigned int i;
> > + u32 reg;
> > + int ret;
> > +
> > + /*
> > + * We're not the first users, there's no need to enable the
> > + * whole controller.
> > + */
> > + if (atomic_inc_return(&csi2rx->count) > 1)
> > + return 0;
> > +
> > + clk_prepare_enable(csi2rx->p_clk);
> > +
> > + printk("%s %d\n", __func__, __LINE__);
>
> Some left over debug...
>
> > +
> > + csi2rx_reset(csi2rx);
> > +
> > + reg = csi2rx->num_lanes << 8;
> > + for (i = 0; i < csi2rx->num_lanes; i++)
> > + reg |= CSI2RX_STATIC_CFG_DLANE_MAP(i, csi2rx->lanes[i]);
> > +
> > + writel(reg, csi2rx->base + CSI2RX_STATIC_CFG_REG);
> > +
> > + ret = v4l2_subdev_call(csi2rx->source_subdev, video, s_stream, true);
> > + if (ret)
> > + return ret;
> > +
> > + /*
> > + * Create a static mapping between the CSI virtual channels
> > + * and the output stream.
> > + *
> > + * This should be enhanced, but v4l2 lacks the support for
> > + * changing that mapping dynamically.
> > + *
> > + * We also cannot enable and disable independant streams here,
> > + * hence the reference counting.
> > + */
> > + for (i = 0; i < csi2rx->max_streams; i++) {
> > + clk_prepare_enable(csi2rx->pixel_clk[i]);
> > +
> > + writel(CSI2RX_STREAM_CFG_FIFO_MODE_LARGE_BUF,
> > + csi2rx->base + CSI2RX_STREAM_CFG_REG(i));
> > +
> > + writel(CSI2RX_STREAM_DATA_CFG_EN_VC_SELECT |
> > + CSI2RX_STREAM_DATA_CFG_VC_SELECT(i),
> > + csi2rx->base + CSI2RX_STREAM_DATA_CFG_REG(i));
I see here that we are setting the data_type to 0 (as we are not setting
it) so effectively capturing everything on the channel(s).
Will we be adding a method to select/filter specific data type?
For instance if we only want to grab YUV data in one stream and only
RGB24 in another. Of course that would not be possible here as is...
Benoit
> > +
> > + writel(CSI2RX_STREAM_CTRL_START,
> > + csi2rx->base + CSI2RX_STREAM_CTRL_REG(i));
> > + }
> > +
> > + clk_prepare_enable(csi2rx->sys_clk);
> > +
> > + clk_disable_unprepare(csi2rx->p_clk);
> > +
> > + return 0;
> > +}
<snip>
