On 07/15/2017 12:05 PM, Sean Young wrote:
Hello,
On Fri, Jul 14, 2017 at 04:14:05AM +0300, Antti Palosaari wrote:
Moikka!
Some remote controller receivers uses HID interface. I looked rc-core
implementation, but failed to find how it could be used for hid. I need
somehow get scancodes and keycodes out from rc-core and write those to
hardware which then generate hid events. Also, I am not sure if kernel
keycodes are same than HID codes, but if not then those should be translated
somehow.
There is rc_g_keycode_from_table() function, which could be used to dump
current scancode:keycode mapping, but calling it in a loop millions of times
is not surely correctly :]
Possibly you could use rc_map_get() to get the entire array. However you
would be limited to rc keymaps which are compiled into the kernel.
It be good to expose an interface to userspace which allows you to read and
write the mapping from IR protocol + scancode to hid usage codes; you could
then have an ir-keytable-like tool to change the keymap.
That was just the plan. I added callback to ir_update_mapping() in order
to get info and new rc_map every-time when it was changed. Then driver
configures hid table accordingly.
I ran some issues:
* HID has very limited set of keys used for remote controllers compared
to linux. So mapping from Linux remote controller to HID went hard.
* NEC 16/24/32 mess. rc_map used by rc-core was typed as NEC16, even
there was NEC24 scancodes. So more self-made heuristics as hw wants NEC32.
So I given it up. I can configure that remote both polling mode via
rc-core and HID. rc-core gives much more flexibility, mainly due to
limited keymap of HID (hw supports only HID page 7, keyboard).
regards
Antti
--
http://palosaari.fi/
