On Thu, Jun 29, 2017 at 09:12:48PM +0200, Mason wrote: > On 29/06/2017 19:50, Sean Young wrote: > > > On Thu, Jun 29, 2017 at 06:25:55PM +0200, Mason wrote: > > > >> $ ir-keytable -v -t > >> Found device /sys/class/rc/rc0/ > >> Input sysfs node is /sys/class/rc/rc0/input0/ > >> Event sysfs node is /sys/class/rc/rc0/input0/event0/ > >> Parsing uevent /sys/class/rc/rc0/input0/event0/uevent > >> /sys/class/rc/rc0/input0/event0/uevent uevent MAJOR=13 > >> /sys/class/rc/rc0/input0/event0/uevent uevent MINOR=64 > >> /sys/class/rc/rc0/input0/event0/uevent uevent DEVNAME=input/event0 > >> Parsing uevent /sys/class/rc/rc0/uevent > >> /sys/class/rc/rc0/uevent uevent NAME=rc-empty > >> input device is /dev/input/event0 > >> /sys/class/rc/rc0/protocols protocol rc-5 (disabled) > >> /sys/class/rc/rc0/protocols protocol nec (disabled) > >> /sys/class/rc/rc0/protocols protocol rc-6 (disabled) > > I had overlooked this. Is it expected for these protocols > to be marked as "disabled"? Ah, good point, I forgot about that. :/ "ir-keytable -p all -t -v" should enable all protocols and test. > >> Opening /dev/input/event0 > >> Input Protocol version: 0x00010001 > >> Testing events. Please, press CTRL-C to abort. > >> ^C > >> > >> Is rc-empty perhaps not the right choice? > > > > rc-empty means there is no mapping from scancode to keycode. When you > > run "ir-keytable -v -t" you should at see scancodes when the driver > > generates them with rc_keydown(). > > So the mapping can be done either in the kernel, or in > user-space by the application consuming the scancodes, > right? That's right, although I do not know of any user-space application that does this; scancodes are mostly useful for debugging. > > From a cursory glance at the driver I can't see anything wrong. > > > > The only thing that stands out is RC5_TIME_BASE. If that is the bit > > length or shortest pulse/space? In the latter case it should be 888 usec. > > Need to locate some docs. > > > It might be worth trying nec, rc5 and rc6_0 and seeing if any of them decode. > > What do you mean? How do I try them? Well, presumably you're using a remote control for testing. It would be useful if you had remotes which could do all protocols that the IR receiver supports, so you can try all three of them. Another way of doing this is using an IR transmitter and using ir-ctl to send scancodes. Sean
