Am Sonntag, den 11.10.2009, 19:29 +0000 schrieb fabio tirapelle: > Hi Hermann > > > Hi Fabio, > > > > > Am Donnerstag, den 08.10.2009, 20:02 +0000 schrieb fabio tirapelle: > > > Hi > > > > > > I have installed mythtv on this configuration: > > > Asus M3N78-VM GF8200 RGVSM > > > AMD Ath64 X2LV 3100BOX6000+ 1MB > > > Haupp. WinTV HVR-1100 -t/a PCI > > > TechniSat SkyStar 2 DVB-S PCI > > > nVidia GeForce 8200 > > > Ubuntu 8.10 - Linux htpc 2.6.27-11-generic > > > > did send to those likely interested too and might be able to give better > > advice. > > > > > Two questions > > > > > > 1) But the Haupp. WinTV will not be found even if I have followed > > > http://www.linuxtv.org/wiki/index.php/Hauppauge_WinTV-HVR-1110 > > > http://ubuntuforums.org/showthread.php?t=623126&page=2 (#12) > > > > > > Output of dmesg > > > > > > [ 13.062214] ACPI: PCI Interrupt Link [LNKA] enabled at IRQ 17 > > > [ 13.062223] b2c2_flexcop_pci 0000:01:06.0: PCI INT A -> Link[LNKA] -> GSI > > 17 (level, low) -> IRQ 17 > > > [ 13.076654] DVB: registering new adapter (FlexCop Digital TV device) > > > [ 13.078432] b2c2-flexcop: MAC address = 00:d0:d7:0d:30:88 > > > [ 13.078664] b2c2-flexcop: i2c master_xfer failed > > > [ 13.078893] b2c2-flexcop: i2c master_xfer failed > > > [ 13.078895] CX24123: cx24123_i2c_readreg: reg=0x0 (error=-121) > > > [ 13.078897] CX24123: wrong demod revision: 87 > > > [ 13.101063] saa7130/34: v4l2 driver version 0.2.14 loaded > > > [ 13.360642] b2c2-flexcop: found 'ST STV0299 DVB-S' . > > > [ 13.360647] DVB: registering frontend 0 (ST STV0299 DVB-S)... > > > [ 13.360768] b2c2-flexcop: initialization of 'Sky2PC/SkyStar 2 DVB-S' at the > > 'PCI' bus controlled by a 'FlexCopIIb' complete > > > [ 13.363507] ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 16 > > > [ 13.363517] saa7134 0000:01:07.0: PCI INT A -> Link[LNKB] -> GSI 16 (level, > > low) -> IRQ 16 > > > [ 13.363523] saa7133[0]: found at 0000:01:07.0, rev: 255, irq: 16, latency: > > 255, mmio: 0x0 > > > > Memory allocation at the PCI bus fails and PCI latency is very high for > > nothing in the end. > > > > > [ 13.363528] saa7133[0]: subsystem: ffff:ffff, board: UNKNOWN/GENERIC > > [card=0,autodetected] > > > > Either the eeprom is corrupted, or more likely, this fails because of > > the previous failing. > > > > > [ 13.363531] saa7133[0]: can't get MMIO memory @ 0x0 > > > [ 13.363538] saa7134: probe of 0000:01:07.0 failed with error -16 > > > [ 13.393682] saa7134 ALSA driver for DMA sound loaded > > > [ 13.393685] saa7134 ALSA: no saa7134 cards found > > > > > > ouput lspci > > > 01:06.0 Network controller: Techsan Electronics Co Ltd B2C2 FlexCopII DVB chip > > / Technisat SkyStar2 DVB card (rev 02) > > > 01:07.0 Multimedia controller: Philips Semiconductors SAA7131/SAA7133/SAA7135 > > Video Broadcast Decoder (rev d1) > > > > > > 2) What kind of DVB-T card will you suggest for my configuration instead of > > "Hauppage WinTv"? > > > > > > > We have some unknowns on the various Hauppauge 1110s, but in general > > they are assumed to be well supported. > > > > They are all auto eeprom detectable and only for latest revisions you > > need some latest mercurial v4l-dvb. These look good now too. > > > > Could you try again with the HVR1110 as the only PCI card? > > I have tried without success > > > > > If this still fails, the mobo seems not to be best treated anyway too, I > > would guess the card is broken. > > What kind of mobo do you suggest? If necessary I can buy a new mobo > > > > > Cheers, > > Hermann > > Thanks Fabio > Hi Fabio, I would try to test the HVR1110 next on another PC with known working PCI hardware, also above different operating systems if possible. We know that the HVR1110s are properly detected on almost all hardware. Before thinking about replacing mobo/PSU, make sure the card is OK. Cheers, Hermann -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
