Jarod Wilson wrote: > With that caveat emptor, here's where the tree that should at least get you 95% of the way > there with that stick resides: > > http://www.kernellabs.com/hg/~mkrufky/lgdt3304-3/ Okay... I built the tip of the archive linked above. It works with my UB435-Q fairly well, built against 2.6.28-15-generic #52-Ubuntu SMP x86_64. I've been able to stream QAM256 content for several hours reliably. Mythfrontend works somewhat... it'll tune the initial channel, but fails afterward. I suspect it is timing out while waiting for the RF tracking filter calibration... it adds about 6 seconds to every tuning operation. [ 812.465930] tda18271: performing RF tracking filter calibration [ 818.572446] tda18271: RF tracking filter calibration complete [ 818.953946] tda18271: performing RF tracking filter calibration [ 825.093211] tda18271: RF tracking filter calibration complete Initialization: [ 217.319831] em28xx: New device USB 2870 Device @ 480 Mbps (1b80:a340, interfa ce 0, class 0) [ 217.319842] em28xx #0: Identified as KWorld PlusTV 340U (ATSC) (card=71) [ 217.320062] em28xx #0: chip ID is em2870 [ 217.448225] em28xx #0: i2c eeprom 00: 1a eb 67 95 80 1b 40 a3 c0 13 6b 10 6a 22 00 00 [ 217.448244] em28xx #0: i2c eeprom 10: 00 00 04 57 00 0d 00 00 00 00 00 00 00 00 00 00 [ 217.448260] em28xx #0: i2c eeprom 20: 44 00 00 00 f0 10 01 00 00 00 00 00 5b 1c c0 00 [ 217.448275] em28xx #0: i2c eeprom 30: 00 00 20 40 20 80 02 20 01 01 00 00 00 00 00 00 [ 217.448290] em28xx #0: i2c eeprom 40: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 [ 217.448304] em28xx #0: i2c eeprom 50: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 [ 217.448319] em28xx #0: i2c eeprom 60: 00 00 00 00 00 00 00 00 00 00 22 03 55 00 53 00 [ 217.448333] em28xx #0: i2c eeprom 70: 42 00 20 00 32 00 38 00 37 00 30 00 20 00 44 00 [ 217.448348] em28xx #0: i2c eeprom 80: 65 00 76 00 69 00 63 00 65 00 00 00 00 00 00 00 [ 217.448362] em28xx #0: i2c eeprom 90: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 [ 217.448376] em28xx #0: i2c eeprom a0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 [ 217.448390] em28xx #0: i2c eeprom b0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 [ 217.448405] em28xx #0: i2c eeprom c0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 [ 217.448419] em28xx #0: i2c eeprom d0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 [ 217.448433] em28xx #0: i2c eeprom e0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 [ 217.448447] em28xx #0: i2c eeprom f0: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 [ 217.448465] em28xx #0: EEPROM ID= 0x9567eb1a, EEPROM hash = 0x2888a312 [ 217.448469] em28xx #0: EEPROM info: [ 217.448472] em28xx #0: No audio on board. [ 217.448475] em28xx #0: 500mA max power [ 217.448479] em28xx #0: Table at 0x04, strings=0x226a, 0x0000, 0x0000 [ 217.448488] em28xx #0: v4l2 driver version 0.1.2 [ 217.454853] em28xx #0: V4L2 device registered as /dev/video0 and /dev/vbi0 [ 217.454889] usbcore: registered new interface driver em28xx [ 217.454895] em28xx driver loaded Any suggestions? Further data needed? Thanks! R C -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
