By the way, may be "C0 00 0C" enable RF receiver?
On 04.08.16 15:03, Oleh Kravchenko wrote:
> I got this from tracing I2C bus of tuner.
>
> Windows driver send this to tuner before set frequency, bandwidth, etc.:
> wC0 | 15 | C0 00 00 00 00 01 01 01 01 01 01 02 00 00 01 | ...............
>
> ; I cut firmware from here, by the way Windows driver use firmware v2.1.8
> wC0 | 2 | 01 01 | ..
>
> ; I don't known what is it, but with(out) it on Linux my tuner work fine!
> ; I think this is calibration data(?)
> wC0 | 6 | 14 00 10 06 E8 03 | ......
> wC0 | 6 | 14 00 11 06 00 00 | ......
> wC0 | 6 | 14 00 23 06 9E 80 | ..#...
> wC0 | 6 | 14 00 24 06 00 00 | ..$...
> wC0 | 6 | 14 00 03 06 08 00 | ......
> wC0 | 6 | 14 00 07 06 32 C8 | ....2.
> wC0 | 6 | 14 00 01 06 01 00 | ......
> wC0 | 6 | 14 00 13 06 00 03 | ......
> wC0 | 6 | 14 00 0C 06 88 13 | ......
> wC0 | 6 | 14 00 0D 06 94 64 | .....d
> wC0 | 6 | 14 00 17 06 00 00 | ......
> wC0 | 6 | 14 00 12 06 00 00 | ......
> wC0 | 6 | 14 00 05 06 BA 00 | ......
> wC0 | 6 | 14 00 04 06 00 02 | ......
> wC0 | 6 | 14 00 16 06 00 00 | ......
> wC0 | 6 | 14 00 02 04 08 00 | ......
> wC0 | 6 | 14 00 01 04 00 00 | ......
> wC0 | 6 | 14 00 11 07 00 00 | ......
> wC0 | 6 | 14 00 08 07 00 00 | ......
> wC0 | 6 | 14 00 02 07 01 00 | ......
> wC0 | 6 | 14 00 05 07 32 C8 | ....2.
> wC0 | 6 | 14 00 0C 07 01 00 | ......
> wC0 | 6 | 14 00 01 07 01 00 | ......
> wC0 | 6 | 14 00 0D 07 00 00 | ......
> wC0 | 6 | 14 00 0E 07 00 00 | ......
> wC0 | 6 | 14 00 10 07 00 00 | ......
> wC0 | 6 | 14 00 0A 07 00 01 | ......
> wC0 | 6 | 14 00 06 07 88 13 | ......
> wC0 | 6 | 14 00 07 07 94 1B | ......
> wC0 | 6 | 14 00 03 07 28 00 | ....(.
> wC0 | 6 | 14 00 13 07 FF FF | ......
> wC0 | 6 | 14 00 0F 07 00 00 | ......
> wC0 | 6 | 14 00 09 07 00 00 | ......
> wC0 | 6 | 14 00 04 07 B0 00 | ......
> wC0 | 6 | 14 00 12 07 10 00 | ......
> wC0 | 6 | 14 00 04 05 00 80 | ......
> wC0 | 6 | 14 00 01 05 01 00 | ......
> wC0 | 6 | 14 00 05 05 00 07 | ......
> wC0 | 6 | 14 00 06 05 01 00 | ......
> wC0 | 6 | 14 00 07 05 7F 00 | ......
>
> ; without C0 00 0C tuner is not work
> wC0 | 3 | C0 00 0C | ...
>
>
>
> On 04.08.16 14:11, Olli Salonen wrote:
>> Hi Oleh,
>>
>> It would seem to me that when you start the clocks here:
>>
>>> "\xC0\x00\x00\x00\x00\x01\x01\x01\x01\x01\x01\x02\x00\x00\x01", 15);
>> You've removed 0c from third octet compared to the default behaviour.
>> However, then later in the sequence you run:
>>
>>> + /* start tuner? */
>>> + if (SI2157_CHIPTYPE_SI2158 == dev->chiptype) {
>>> + memcpy(cmd.args, "\xC0\x00\x0C", 3);
>> Ie. there you do change the parameter in the third octet to 0c. I'm
>> wondering what's the reason and significance of that. Was there a
>> problem that you solved with this approach? Why is this way better
>> than the previous way? I'm trying to understand that.
>>
>> Cheers,
>> -olli
>>
>>
>>
>> On 4 August 2016 at 13:26, Oleh Kravchenko <oleg@xxxxxxxxxx
>> <mailto:oleg@xxxxxxxxxx>> wrote:
>>
>> Hi Olli,
>>
>> Looks like I miss something, what parameter do you mean?
>>
>> On 04.08.16 13:08, Olli Salonen wrote:
>> > Hi Oleh,
>> >
>> > Do you have any idea of what this parameter change does? I have
>> a gut
>> > feeling that this is an option that's not Si2158-specific, but a
>> > parameter that's valid for the other tuners as well.
>> >
>> > Do you know what this parameter will actually do? If so, it would be
>> > better to add this as a configuration option for the Si2157. Your
>> > patch will now change the behaviour even for devices that you
>> probably
>> > have not tested.
>> >
>> > Cheers,
>> > -olli
>> >
>> > On 4 August 2016 at 10:54, Oleh Kravchenko <oleg@xxxxxxxxxx
>> <mailto:oleg@xxxxxxxxxx>
>> > <mailto:oleg@xxxxxxxxxx <mailto:oleg@xxxxxxxxxx>>> wrote:
>> >
>> > Signed-off-by: Oleh Kravchenko <oleg@xxxxxxxxxx
>> <mailto:oleg@xxxxxxxxxx>
>> > <mailto:oleg@xxxxxxxxxx <mailto:oleg@xxxxxxxxxx>>>
>> > ---
>> > drivers/media/tuners/si2157.c | 34
>> > +++++++++++++++++++++++++++-------
>> > drivers/media/tuners/si2157_priv.h | 1 +
>> > 2 files changed, 28 insertions(+), 7 deletions(-)
>> >
>> > diff --git a/drivers/media/tuners/si2157.c
>> > b/drivers/media/tuners/si2157.c
>> > index 57b2508..d7035a5 100644
>> > --- a/drivers/media/tuners/si2157.c
>> > +++ b/drivers/media/tuners/si2157.c
>> > @@ -103,12 +103,21 @@ static int si2157_init(struct
>> dvb_frontend *fe)
>> > goto warm;
>> >
>> > /* power up */
>> > - if (dev->chiptype == SI2157_CHIPTYPE_SI2146) {
>> > - memcpy(cmd.args,
>> > "\xc0\x05\x01\x00\x00\x0b\x00\x00\x01", 9);
>> > - cmd.wlen = 9;
>> > - } else {
>> > - memcpy(cmd.args,
>> >
>> "\xc0\x00\x0c\x00\x00\x01\x01\x01\x01\x01\x01\x02\x00\x00\x01", 15);
>> > - cmd.wlen = 15;
>> > + switch (dev->chiptype) {
>> > + case SI2157_CHIPTYPE_SI2146:
>> > + memcpy(cmd.args,
>> > "\xc0\x05\x01\x00\x00\x0b\x00\x00\x01", 9);
>> > + cmd.wlen = 9;
>> > + break;
>> > +
>> > + case SI2157_CHIPTYPE_SI2158:
>> > + memcpy(cmd.args,
>> >
>> "\xC0\x00\x00\x00\x00\x01\x01\x01\x01\x01\x01\x02\x00\x00\x01", 15);
>> > + cmd.wlen = 15;
>> > + break;
>> > +
>> > + default:
>> > + memcpy(cmd.args,
>> >
>> "\xc0\x00\x0c\x00\x00\x01\x01\x01\x01\x01\x01\x02\x00\x00\x01", 15);
>> > + cmd.wlen = 15;
>> > + break;
>> > }
>> > cmd.rlen = 1;
>> > ret = si2157_cmd_execute(client, &cmd);
>> > @@ -204,6 +213,16 @@ skip_fw_download:
>> > if (ret)
>> > goto err;
>> >
>> > + /* start tuner? */
>> > + if (SI2157_CHIPTYPE_SI2158 == dev->chiptype) {
>> > + memcpy(cmd.args, "\xC0\x00\x0C", 3);
>> > + cmd.wlen = 3;
>> > + cmd.rlen = 1;
>> > + ret = si2157_cmd_execute(client, &cmd);
>> > + if (ret)
>> > + goto err;
>> > + }
>> > +
>> > /* query firmware version */
>> > memcpy(cmd.args, "\x11", 1);
>> > cmd.wlen = 1;
>> > @@ -506,8 +525,9 @@ static int si2157_remove(struct i2c_client
>> > *client)
>> > }
>> >
>> > static const struct i2c_device_id si2157_id_table[] = {
>> > - {"si2157", SI2157_CHIPTYPE_SI2157},
>> > {"si2146", SI2157_CHIPTYPE_SI2146},
>> > + {"si2157", SI2157_CHIPTYPE_SI2157},
>> > + {"si2158", SI2157_CHIPTYPE_SI2158},
>> > {}
>> > };
>> > MODULE_DEVICE_TABLE(i2c, si2157_id_table);
>> > diff --git a/drivers/media/tuners/si2157_priv.h
>> > b/drivers/media/tuners/si2157_priv.h
>> > index d6b2c7b..677fa00 100644
>> > --- a/drivers/media/tuners/si2157_priv.h
>> > +++ b/drivers/media/tuners/si2157_priv.h
>> > @@ -42,6 +42,7 @@ struct si2157_dev {
>> >
>> > #define SI2157_CHIPTYPE_SI2157 0
>> > #define SI2157_CHIPTYPE_SI2146 1
>> > +#define SI2157_CHIPTYPE_SI2158 2
>> >
>> > /* firmware command struct */
>> > #define SI2157_ARGLEN 30
>> > --
>> > 2.7.3
>> >
>> > --
>> > To unsubscribe from this list: send the line "unsubscribe
>> > linux-media" in
>> > the body of a message to majordomo@xxxxxxxxxxxxxxx
>> <mailto:majordomo@xxxxxxxxxxxxxxx>
>> > <mailto:majordomo@xxxxxxxxxxxxxxx
>> <mailto:majordomo@xxxxxxxxxxxxxxx>>
>> > More majordomo info at
>> http://vger.kernel.org/majordomo-info.html
>> >
>> >
>>
>> --
>> Best regards,
>> Oleh Kravchenko
>>
>> Senior Software Developer, CMS | skype: oleg_krava | Email:
>> oleg@xxxxxxxxxx <mailto:oleg@xxxxxxxxxx>
>>
>>
>>
--
Best regards,
Oleh Kravchenko
Senior Software Developer, CMS | skype: oleg_krava | Email: oleg@xxxxxxxxxx
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
