On Mon, 20 Jul 2009, Jarod Wilson wrote:
> The dvb side of the pcHDTV HD-3000 doesn't work since at least 2.6.29.
> The crux of the problem is this: the HD-3000's device ID matches the
> modalias for the cx8800 driver, but not the cx8802 driver, which is
> required to set up the digital side of the card. You can load up
> cx8802 just fine, but cx88-dvb falls on its face, because the call
> to cx8802_register_driver() attempts to traverse the cx8802_devlist,
> which is completely empty. The list is only populated by the
> cx8802_probe() function, which never gets called for the HD-3000, as
> its device ID isn't matched by the cx8802 driver, so you wind up
This isn't right. The cx8802 has never had anything in its mod alias other
than the generic 14f1/8802 vendor/device with wildcards for
sub-vendor/device. Which should match the HD-3000 as well as all other
cx88 based digital cards. So cx8802_probe() should be called with the
existing id table. Something else must be going on. Maybe there is
something wrong with your PCI and function 2 isn't showing up? Or it could
be that function 2 is disabled in the eeprom. Make sure lspci shows the
mpeg function listed:
02:04.2 Multimedia controller: Conexant CX23880/1/2/3 PCI Video and Audio Decoder [MPEG Port] (rev 05)
Subsystem: pcHDTV pcHDTV HD3000 HDTV
Flags: bus master, medium devsel, latency 64, IRQ 18
Memory at c5000000 (32-bit, non-prefetchable) [size=16M]
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
