On Tuesday 24 November 2015 10:13:17 Finn Thain wrote:
On Tue, 24 Nov 2015, Ondrej Zary wrote:
On Tuesday 24 November 2015, Finn Thain wrote:
On Mon, 23 Nov 2015, Ondrej Zary wrote:
PDMA seems to be broken in multiple ways. NCR5380_pread cannot
process less than 128 bytes. In fact, 53C400 datasheet says that
it's HW limitation: non-modulo-128-byte transfers should use PIO.
Adding
transfersize = round_down(transfersize, 128);
to generic_NCR5380_dma_xfer_len() improves the situation a bit.
After modprobe, some small reads (8, 4, 24 and 64 bytes) are done
using PIO, then eight 512-byte reads using PDMA and then it fails on
a 254-byte read. First 128 bytes are read using PDMA and the next
PDMA operation hangs waiting forever for the host buffer to be
ready.
A 128-byte PDMA receive followed by 126-byte PDMA receive? I don't see
how that is possible given round_down(126, 128) == 0. Was this the
actual 'len' argument to NCR5380_pread() in g_NCR5380.c?
No 126-byte PDMA. The 126 bytes were probably lost (or mixed with the
next read?).
When you said, the "PDMA operation hangs waiting forever", I figured that
you had hit an infinite loop in NCR5380_pread()... but now I'm lost.
My main concern here is to confirm that I didn't break anything e.g. with
patch 24 or 41. It would be nice to know that this hang is not the result
of a new bug.
The next read was also 254 bytes so another 128-byte PDMA transfer.
Then modified NCR5380_information_transfer() to transfer the remaining
data (126 bytes in this case) using PIO. It did not help, the next PDMA
transfer failed too.
AFAICT, no change to NCR5380_information_transfer() should be needed. It
was always meant to cope with the need to split a transfer between (P)DMA
and PIO.
Instead of fixing split transfers, simply forced everything non-modulo-128 to
PIO:
--- a/drivers/scsi/g_NCR5380.c
+++ b/drivers/scsi/g_NCR5380.c
@@ -703,6 +703,10 @@ static int generic_NCR5380_dma_xfer_len(struct scsi_cmnd *cmd)
!(cmd->SCp.this_residual % transfersize))
transfersize = 32 * 1024;
+ /* 53C400 datasheet: non-modulo-128-byte transfers should use PIO */
+ if (transfersize % 128)
+ transfersize = 0;
+
return transfersize;
}
It seems to work and greatly improves performance:
# hdparm -t --direct /dev/sdb
/dev/sdb:
Timing O_DIRECT disk reads: 4 MB in 4.84 seconds = 846.15 kB/sec
--
Ondrej Zary
--
To unsubscribe from this list: send the line "unsubscribe linux-m68k" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
