Re: [RFC PATCH v3 6/8] leds: trigger: add hardware-phy-activity trigger

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Mon, Nov 08, 2021 at 10:02:22PM -0800, Randy Dunlap wrote:
> On 11/8/21 6:26 PM, Ansuel Smith wrote:
> > diff --git a/drivers/leds/trigger/Kconfig b/drivers/leds/trigger/Kconfig
> > index dc6816d36d06..b947b238be3f 100644
> > --- a/drivers/leds/trigger/Kconfig
> > +++ b/drivers/leds/trigger/Kconfig
> > @@ -154,4 +154,32 @@ config LEDS_TRIGGER_TTY
> >   	  When build as a module this driver will be called ledtrig-tty.
> > +config LEDS_TRIGGER_HARDWARE_PHY_ACTIVITY
> > +	tristate "LED Trigger for PHY Activity for Hardware Controlled LED"
> > +	depends on LEDS_HARDWARE_CONTROL
> > +	help
> > +	  This allows LEDs to be configured to run by hardware and offloaded
> > +	  based on some rules. The LED will blink or be on based on the PHY
> 
> 	                                          or be "on" based on the PHY
> 
> > +	  Activity for example on packet receive or based on the link speed.
> 
> 	  activity
> 
> > +
> > +	  The current supported offload triggers are:
> > +	  - blink_tx: Blink LED on tx packet receive
> > +	  - blink_rx: Blink LED on rx packet receive
> > +	  - keep_link_10m: Keep LED on with 10m link speed
> > +	  - keep_link_100m: Keep LED on with 100m link speed
> > +	  - keep_link_1000m: Keep LED on with 1000m link speed
> > +	  - keep_half_duplex: Keep LED on with half duplex link
> > +	  - keep_full_duplex: Keep LED on with full duplex link
> > +	  - option_linkup_over: Blink rules are ignored with absent link
> > +	  - option_power_on_reset: Power ON Led on Switch/PHY reset
> > +	  - option_blink_2hz: Set blink speed at 2hz for every blink event
> > +	  - option_blink_4hz: Set blink speed at 4hz for every blink event
> > +	  - option_blink_8hz: Set blink speed at 8hz for every blink event
> > +
> > +	  These blink modes are present in the LED sysfs dir under
> > +	  hardware-phy-activity if supported by the LED driver.
> > +
> > +	  This trigger can be used only by LEDs that supports Hardware mode
> 
> 	                                             support Hardware mode.
> 
> 
> Ansuel, do you read and consider these comments?
> It's difficult to tell if you do or not.
>

Yes and with every new version I'm fixing the errors.
Just we are changing implementation many times and more errors comes up.
Thanks a lot for the comments and sorry if I'm not answering them.

> thanks.
> -- 
> ~Randy

-- 
	Ansuel



[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux OMAP]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux