On Thu, Sep 10, 2020 at 10:31:12PM +0200, Marek Behun wrote: > On Thu, 10 Sep 2020 19:34:35 +0100 > Russell King - ARM Linux admin <linux@xxxxxxxxxxxxxxx> wrote: > > > On Thu, Sep 10, 2020 at 08:31:54PM +0200, Andrew Lunn wrote: > > > Generally the driver will default to the hardware reset blink > > > pattern. There are a few PHY drivers which change this at probe, but > > > not many. The silicon defaults are pretty good. > > > > The "right" blink pattern can be a matter of how the hardware is > > wired. For example, if you have bi-colour LEDs and the PHY supports > > special bi-colour mixing modes. > > > > Have you seen such, Russell? This could be achieved via the multicolor > LED framework, but I don't have a device which uses such LEDs, so I > did not write support for this in the Marvell PHY driver. > > (I guess I could test it though, since on my device LED0 and LED1 > are used, and this to can be put into bi-colour LED mode.) I haven't, much to my dismay. The Macchiatobin would have been ideal - the 10G RJ45s have bi-colour on one side and green on the other. It would have been useful if they were wired to support the PHYs bi- colour mode. -- RMK's Patch system: https://www.armlinux.org.uk/developer/patches/ FTTP is here! 40Mbps down 10Mbps up. Decent connectivity at last!
