Sorry, I had just sent v4 without it. However, I’ve now sent v5 with the summary. Best regards, Álvaro. > El 4 jun 2020, a las 15:53, Pavel Machek <pavel@xxxxxx> escribió: > > On Thu 2020-06-04 15:43:35, Álvaro Fernández Rojas wrote: >> Hi Pavel, >> >>> El 4 jun 2020, a las 15:40, Pavel Machek <pavel@xxxxxx> escribió: >>> >>> On Thu 2020-06-04 15:35:06, Álvaro Fernández Rojas wrote: >>>> HI Pavel, >>>> >>>> Right now, only one hw blinking interval is supported, but up to two hw blinking intervals can be configured in the controller. >>>> This patch just adds support for the second hw blinking interval. >>>> >>>> BTW, I will send v4 which should clarify that each LED can be configured in 4 modes: >>>> 0: On >>>> 1: HW Blinking (Interval 1) >>>> 2: HW Blinking (Interval 2) >>>> 3: Off >>>> >>>> Until now we were only using 3 modes: >>>> 0: On >>>> 1: HW Blinking (Interval 1) >>>> 3: Off >>> >>> So the issue is .... there are like 5 LEDs and they can be on or off >>> or blinking with at most 2 different intervals? >>> Pavel >> >> Yes, the controller supports two different blinking delays (intervals), and LEDs can either be on, off or assigned to one of the two blinking delays. >> However, the current upstream controller only supports one blinking delay. This patch just adds support for both blinking delays instead of just one. >> > > Ok. Please put this kind of summary in comment somewhere. > > Best regards, > Pavel > > -- > (english) http://www.livejournal.com/~pavelmachek > (cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html
