Luca
On 3/5/20 5:01 AM, Luca Weiss wrote:
On Donnerstag, 27. Februar 2020 20:50:40 CET Dan Murphy wrote:
Luca
On 2/27/20 12:50 PM, Luca Weiss wrote:
Add a driver for the SGMICRO SGM3140 Buck/Boost Charge Pump LED driver.
This device is controller by two GPIO lines, one for enabling the LED
and the second one for switching between torch and flash mode.
The device will automatically switch to torch mode after being in flash
mode for about 250-300ms, so after that time the driver will turn the
LED off again automatically.
Signed-off-by: Luca Weiss <luca@xxxxxxxxx>
---
You seem to be missing the devictree bindings doc for the GPIOs.
As written in the initial email:
I will also write dt bindings for the driver once I have "strobe"
working.
NACK.
We review bindings as part of the code. And we want to understand what
bindings the code will be using
You will get better guidance if the patch set contains the documentation
so we can understand what is being proposed.
Dan
